Charlyne 95 Z28 M6

[DETROITMUSCLE]

If your going to drive it in the rain then a drag radial will work just drive slowly and make sure you don't drive with them balding in the rain. Most guys drive under 50mph on the freeway with DRs and rain some even slower than that if that gives you any indication.

[ThreeHonks]

just get the slick. you will be much happier, as far as I know your car doesnt get DD duty. I have an ET DRAG on my car and still take it to woodward

[kammi10]

just get the slick. you will be much happier, as far as I know your car doesnt get DD duty. I have an ET DRAG on my car and still take it to woodward

you also dont bring your car in the rain. he obviously does by asking that question

[ThreeHonks]

you also dont bring your car in the rain. he obviously does by asking that question

I wouldnt really want to chance driving on a drag radial in the rain either. Sure, it'd be better than a bias ply slick, but its still a drag tire and you are going to take a chance

[1bad83ta]

I got caught in the rain once in my TA with the BFG Radials and I hit a small patch of water and almost s**t myself as my car suddenly found its way into the other lane. Of course they were not new so the "tread" wasn't as deep as it should have been but they do not perform in the water well. They are pretty damn good at hydroplaning though!

[Fox Slaughter]

I'm not gonna drive it in the rain. If it's raining I don't go to Woodward. I asked because you could always get stuck in the rain. The car has on been driven in the rain a few times because my DD burned and exhaust valve which I am going to fix this weekend.

The car is strictly gonna be a after work and weekend car.

[JoeliusZ28]

2 sets of tires. problem solved.

[Fox Slaughter]

That takes 2 pairs of rims.

[Fox Slaughter]

Well I have to hold off on purchasing my axle because of some paint work that has to be done, minor work but don't ask I'll feel like a dumb ***.

So I think I am going to purchase:

TunerCats
Lower Control Arms
Lower Control Arm relocation brackets
QTP Eletric Cut outs

[Fox Slaughter]

Well I just order 3/4 of a grand worth of parts.

TunerCATs.
BMR Chrome Moly Lower Control Arms
BMR Bolt in lower control arm relocation
BMR Chrome Moly Strut Brace
BMR Chrome Moly Adjustable Panhard Bar

[my95z28]

Those are always fun orders to place. I would have recommended other parts, but meh, its your money.

[Darren]

I'll be that guy, what happened paint wise? That car was mint to my understanding...

[Fox Slaughter]

It involved never leaving the car in gear and in storage since it was in a warehouse they left it in gear, me being a dumb ass didn't check. Started it up, let the clutch up and then put it back in but since I was sitting in it sideways a Porsche Boxster exhaust stopped me. It chipped the paint in about a half dollar size right where it bumped and then flexed the bumper so right below the headlight cracked.

[c0ncEpT]

Send the strut tower brace back if you think its actually going to do something. There just for looks....

[Fox Slaughter]

Strut brace is removed from my order.

So it's now 660 out of the 3k I was gonna spend for the axle setup. What else should I purchase?