Charlyne 95 Z28 M6

[ryanwarby01]

But, looking forward to the build!

[Fox Slaughter]

This build won't happen till probably July because I am going to be switching jobs.

But for a teaser here on some build specs.

Block: Converted to a 4 bolt.
Bore: 4.040 (its already 30 over but needs to be bored because some are a little lose on the .030 over)
Crankshaft: 3.75" Forged Callies Dragonslayer
Rods: 6" Forged Callies Ultra I beams
Pistons: Diamond -31cc Dish Pistons Forged, possibly a custom order from them.
Caps: Howard Billet 4 bolt caps.
Compression Ratio: Undecided

So if you do the calculations its going to be a 385ci with a compression of Undecided.

I'm not going to expose the top end yet because I still am working on deciding what I want to go with, have a pretty good idea but not sure yet.

[meissen]

Put it this way, if you have a money tree a LT1 is a wood chipper!

That is my new favorite quote.

[Fox Slaughter]

Fitting that is since I am a tree trimmer and shove lots of trees through the chipper. I probably chipped a few money trees too! Damn I'm digging through the chips tomorrow.

[Lucky SOB]

Nice boat anchor you have there

[Fox Slaughter]

I bought it for my dad to keep his 30ft Sea Ray stable in hurricane force winds.

[ryanwarby01]

Fitting that is since I am a tree trimmer and shove lots of trees through the chipper. I probably chipped a few money trees too! Damn I'm digging through the chips tomorrow.

I remembered that, being I work for Vermeer and all.

[Fox Slaughter]

I remembered that, being I work for Vermeer and all.

Ah yes I forgot that haha.

Now looking at Rear Main Caps, Howards makes a Dry Sump, Wet Sump, both says up to 85. Would these work? I can't seem to find any other ones.

[c0ncEpT]

Solid roller and an LF88. Ship it.

[Fox Slaughter]

Solid roller and an LF88. Ship it.

Mind you this engine will be taking shape hopefully around July maybe August.

[Fox Slaughter]

Alright I have been absent for a while due to jumping through hoops to get employed by DTE Energy. Got the job so funds are starting to build.

I think I have lost my mind though haha. Sadly, my July/August plans have been obviously shot. So I hope to build this engine over winter.
The plan is to have it done, ready to drop in by next spring. We all know how plans go though.

Speaking of which, the plans have changed on this.

New Plans:
Same bottom end as before, compression is going to be 9:1.
Topend all I'm going to say is going to be TFS 21* heads by AI.
The rest of the top end is going to be a secret.

Once I get situated with my finances again I will be ordering in parts.

[DETROITMUSCLE]

Sounds like another FI build

[Fox Slaughter]

Does that stand for Force Induction or Fuel Injection? If so, you are part right and part wrong.

[kyleozzie]

Yaaa another ltx that's gonna be well slow of course I am doing a turbo build right now....

Sent from my SCH-I405

[Fox Slaughter]

Yay hair dryers all around for everyone!