lizs head/cam swap

[meissen]

Congrats on the progress, Liz!

[my95z28]

Looking good Liz! Hopefully you don't have the same problems that a guy at work has with AFR, valve guides are completly shot after 6k miles. AFR seems to be taking care of him though, so I think that they have pretty good customer service.

[81DaytonaPaceCar]

Progress is a good thing...

[MP81]

AFR FTW!!!

[MORNINGSTAR2101]

my engine is no longer headless simply beautiful. and yes, my buddy chris fits in the bay too.. ..

[JoeliusZ28]

[Virtue]

i have some long breaker bars but usually just use the end of a jack handle

[cobalt camaro]

that's what i do, i have a nice 2 foot section and 3 foot section of pipe with .25" wall thickness, works great.

[MP81]

Coulda used a pipe as an extension...

[Will]

It has to be better than the one I use at my house . . . the handle off the floor jack.

[MORNINGSTAR2101]

lmao.

that bolt was definitely on there. the breaker bar i had wasnt the biggest but i couldnt budge it by myself.

it wasnt the longest, but it was definitely girthy, thats what happens when you let the kevin pick out and construct the breaker bar

[02redz28]

looking good... 2 man power....hahahaha

[JoeliusZ28]

So those guns you carry around are just for looks?

lmao.

that bolt was definitely on there. the breaker bar i had wasnt the biggest but i couldnt budge it by myself.

[MP81]

Oh, missed that part.

[1BADAIR]

I would assume so, since I really didn't have a problem going to 155 lb-ft.


EDIT: Just looked it up: 240 lb-ft.

But then it says to put the old on on and torque to that spec...then take it off and torque the new one on to 37 lb-ft...

37ft lb + 140 degrees.
remember. never use a torque wrench to loosen a bolt and don't pull on the wrench after it clicks