Charlyne 95 Z28 M6

[JoeliusZ28]

AutoX cars don't use upgraded valvetrains with stock rear ends!

sure they do! In fact ive never seen any autox / road race fbody use anything but the 10 bolt yet. Not saying they arent out there, i plan on 9"/s60 eventually

[Fox Slaughter]

Do me a favor. Take a picture of your rear brake line routing. I can't seem to figure it out with the new axle. They have the factory clips on the axle but unless I start bending the lines it won't fit right.

[Fox Slaughter]

Last part of the suspension arrived today.

DSCN0210.JPG
UMI Chromoly Torque Arm.
I was going to go black so it matched the rest of my rear end pieces but by time I realized I didn't change it, it was already shipped =/ eh.

Viking forgot to sent me the bearings and spanner wrench so that was shipped yesterday so I can put the coilovers together.

Home to have the Clutch in, Torque Arm, coilovers, and driveshaft in this weekend.

[BP_Z28]

chromoly.. big spenda!

[Fox Slaughter]

chromoly.. big spenda!

Eh it cost about the same as the clutch and for sure less than 2 slicks and 2 front runners haha.

[JoeliusZ28]

Last part of the suspension arrived today.

[ATTACH=CONFIG]47714[/ATTACH]
UMI Chromoly Torque Arm.
I was going to go black so it matched the rest of my rear end pieces but by time I realized I didn't change it, it was already shipped =/ eh.

My eyes!!!

[meissen]

Between the lime green and the red torque arm your car is going to be christmas themed

[Darren]

Charlyne 95 Z28 M6

Between the lime green and the red torque arm your car is going to be christmas themed

Kawasaki Green TYVM!


Sent from my iPhone 5 using Tapatalk

[Fox Slaughter]

If Darren was a real powder coater I would have him do my sway bar and strip this puppy down and coat her Kawasaki Green but someone is to cheap to spring for this.


industrial-ovens-image2.jpg

[Darren]

Charlyne 95 Z28 M6

If Darren was a real powder coater I would have him do my sway bar and strip this puppy down and coat her Kawasaki Green but someone is to cheap to spring for this.


[ATTACH=CONFIG]47722[/ATTACH]

Buy me a oven ill do it for free and cut ya in on the bizz.


Sent from my iPhone 5 using Tapatalk

[DETROITMUSCLE]

Weigh that tq arm please I have the exact same one here in mild steel and I'm curious to see the difference.

[Fox Slaughter]

Do you just want the torque arm or do you want the mount weighed also?

EDIT:

The bathroom scale says 20lbs for the arm and 10lbs for the mount. So 30lbs total.

UMI says on their setups its about a 3 - 4lbs difference plus stronger.

[Fox Slaughter]

Dropped these off at my neighbors shop and had him weld some flanges and o2 bungs in.

DSCN0215.JPGDSCN0216.JPGDSCN0217.JPG

[QuickTop]

Im gonna have to get you and @JoeliusZ28 in a room and write me a list of worthy suspension/ stiffening products. looks great though! dont think because i dont post often im not watching

[Fox Slaughter]

Im gonna have to get you and @JoeliusZ28 in a room and write me a list of worthy suspension/ stiffening products. looks great though! dont think because i dont post often im not watching

Confessions of a Teenage Stalker