UPDATE! Project 11secV6 underway

[JoeliusZ28]

ok that would make perfect sense.... didnt even think of that.

[WMCC Gary]

actually i had to get an adjustable one for when i lowered my car to recenter the rear end

I was just about to post the same thing until I seen your post.

[97rs4life]

yea mine is a UMI non-adjustable PHR since it is not getting lowered. I am already low with the gfx. lol

[b.a.camaro]

I would go with single just her in and then your done no adjustments to make and the rear end should be perfectly centered

[97rs4life]

Ordered up my carpeting for the rear seat delete. stockinteriors.com sent me samples and I found one that matched pretty close to the stock. Should be here in like a week.

[97rs4life]

The place building the engine for me is ready for me to send them the parts I have collected. The block has been honed and all machined out and ready to be put back together. So I have about 4 boxes heading their way tomorrow. Looks like I should be getting my engine here in a few weeks then.

Also I have the carpet for the rear seat delete. Just need to order some 18" nitrous lines and route them before I carpet it as I will need to drill a couple holes for them. The carpet I got from stockinteriors.com and it matches up extremely well with my interior. I am happy about that.

Also what do you guys think about the name Project: "Holden Your Breath" for my car build? Kind of creative with the use of holden in it and all. I dunno. I am just trying to get something other than 11secv6 as that is pretty generic. lol

[Derek]

The place building the engine for me is ready for me to send them the parts I have collected. The block has been honed and all machined out and ready to be put back together. So I have about 4 boxes heading their way tomorrow. Looks like I should be getting my engine here in a few weeks then.

Also I have the carpet for the rear seat delete. Just need to order some 18" nitrous lines and route them before I carpet it as I will need to drill a couple holes for them. The carpet I got from stockinteriors.com and it matches up extremely well with my interior. I am happy about that.

Also what do you guys think about the name Project: "Holden Your Breath" for my car build? Kind of creative with the use of holden in it and all. I dunno. I am just trying to get something other than 11secv6 as that is pretty generic. lol

how about "project veesix slomaro" until your car gets out and proves itself only kidding, i do like that holden your breath name.

[JoeliusZ28]

lol i like it

[DETROITMUSCLE]

sounds like a suiting name to me. I'm so psyched to see this all come together and get some numbers for your car, should be very impressive to say the least.

[twoanimal4]

Outstanding job travis! Keep up the great work and taking care of my problems also...Got them wires ty,,,,

[BP_Z28]

I like the name !

[cobalt camaro]

how about "holdmaro" i don't know, but sounds like your project is going pretty smooth, keep it up can't wait to see how she turns out.

[97rs4life]

knives start flying tomorrow.

i.e. engine is getting opened for the first time and I am test fitting the holden intakes before sending the lower out to get ported.

[silver6_maro]

knives start flying tomorrow.

i.e. engine is getting opened for the first time and I am test fitting the holden intakes before sending the lower out to get ported.

SWEET, hope everything goes smoooth, and dont try to smile too much!!

I like the name too!!

[badinfluence]

did you decide on a name for it?