UPDATE! Project 11secV6 underway

[ITSSLOW]

I love that rear seat delete and nitrous bottle rack!

[97rs4life]

I also ordered up the 2nd bottle heater and blowdown tube. So now just to find carpet...

[phoenix_rising]

Man I hope you know what you are doing man. Thats a s*itload of N20!!!

[97rs4life]

Man I hope you know what you are doing man. Thats a s*itload of N20!!!

only 20lbs total.

Means more track time before fills and consistent pressure throughout.

Plus I eventually will be doing 200+ shots of nitrous once engine is broken in and tuning is done, need the two bottles.

[s.reef]

Looks good cant wait to see that covered in carpet

[97rs4life]

Looks good cant wait to see that covered in carpet

yup, I ordered some carpet samples so I will see what I can do about that.

[GETGONE]

Have you seen those CO2 pressure stabilizers for nitrous kits? Those look pretty good and keep you from needing bottle heaters and keep the pressure constant throughout the whole tank. I think it was the last issue of GMHTP that had an article on the kit.

[97rs4life]

Have you seen those CO2 pressure stabilizers for nitrous kits? Those look pretty good and keep you from needing bottle heaters and keep the pressure constant throughout the whole tank. I think it was the last issue of GMHTP that had an article on the kit.

yea the NANO kits is what they are. A bit too much $$ wise for me to see a need for them. They keep the pressure up and they have shown to help your 1/4 times as well by a few tenths along with some extra hp. I can just up the shot if I need the extra power.

Neat idea though for sure

[BP_Z28]

looking good

[meissen]

Looks awesome!

[97rs4life]

Did some work on the car today. I started it up and drove it into the shop. Was a nice feeling hearing it pur again before going under the knife. lol.

I put on my TA girdle and stud kit to strengthen the rear end. Went pretty good, the stupid torque wrench was acting up but I got it on alright. Anyone have this girdle and how far do the preload bolts stick out for you guys?

I also did some underhood appearance work by doing the !latch wire mod. This is where you took the hood latch that runs along the driver's side and hide it under the fender to clean up the engine bay.

Plan on doing more tomorrow on the car.

On a side note I got some carpet samples today and found out which color I need to order. So that is now on order for the rear seat delete.

[s.reef]

Sounds good...so the TA cover install went pretty smooth? Im thinkin about getting one

[97rs4life]

Sounds good...so the TA cover install went pretty smooth? Im thinkin about getting one

yea smooth, just make sure you have a torque wrench and also make sure you can jack the car up and down to reach the top bolts on the cover. You cannot get the wrench up top if you have it all on the ground. I had it on a hoist so it was easier

[JoeliusZ28]

Ive got a TA girdle... but its not installed yet. Will be before the M&G so ill get pictures for you when i get around to it.

[s.reef]

Ive got a TA girdle... but its not installed yet. Will be before the M&G so ill get pictures for you when i get around to it.

Cool that would be great, Im hoping when i do the camswap we will have enought time to do the gears as well