Project round two: 1992 Chevy Camaro

[Darren]

Project round two: 1992 Chevy Camaro

I dont think id risk my insurance rates being increased over a $120 windshield.

Im not claiming it but if I did it would not raise my rates. A glass claim on my insurance is nothing against me. Although my car needs to be in one piece for me to make a claim... I also wish it was $120 piece of glass. Try closer to$300-$350.


Sent from my iPhone 5 using Tapatalk

[Darren]

Project round two: 1992 Chevy Camaro

Did not waste anytime after vacation:

Sanded the freshly painted primer



Test fitted yet another set of calve covers



And started to prep the rest of the front end, again...









Tomorrow will paint engine bay again and jeep plugging away.


Sent from my iPhone 5 using Tapatalk

[JoeliusZ28]

Dude that SBC looks nice work!!!

Ive always wanted those valve covers but they wont work with 24x

[Darren]

Project round two: 1992 Chevy Camaro

Dude that SBC looks nice work!!!

Ive always wanted those valve covers but they wont work with 24x

Thanks I guess I didnt post these pictures...










Sent from my iPhone 5 using Tapatalk

[nascarnate326]

you've been doing work!

[Iroc'nthe87]

Looks good

[deeznuts94]

Sweet man! Lookin good!

[JoeliusZ28]

Ive always wanted a clean carbed setup like that... just not in my 4th gen

[birdie2000]

Good choice on all the black on that engine...

Lookin good man!

[hoogiesngrinderz]

I agree!

Should look good in there. Make sure to detail the heads w/ black around the intake. I would have went with the standard black RTV for that application by my goto is typically the copper high temp

[meissen]

Hard to imagine your old slow 305 compared to this - awesome job dude!

[Darren]

Ive always wanted a clean carbed setup like that... just not in my 4th gen

Yeah its going to be really nice. Jon was looking through my wiring harness for me, and then in turn showing me what I wont need. Its going to be really nice to hack (figure of speech) that harness up and have minimal wires in the engine bay.

Good choice on all the black on that engine...

Lookin good man!

Oh just wait, there is going to be some color, I just hope its the right amount and not too much....

I agree!

Should look good in there. Make sure to detail the heads w/ black around the intake. I would have went with the standard black RTV for that application by my goto is typically the copper high temp

its what I had in the garage, and I was at the point where I had some help and I wanted it to go back together. You wont see it when I am done anyhow.

Hard to imagine your old slow 305 compared to this - awesome job dude!

haha yes, but only difference is I got to drive that car a lot! I have not even driven this car for 2 solid weeks since ownership! I am hoping this is going to be a fun car to drive, I am told it will be but I cant wait till I get to experience it.

[Darren]

Project round two: 1992 Chevy Camaro








Sent from my iPhone 5 using Tapatalk

[Lucky SOB]

Wow that looks great Darren!

[Darren]

Engine bay is done!

Had a lot of help. Thanks guys (you know who ya are)

Now how this thing go back together?


Sent from my iPhone 5 using Tapatalk