Announcement

Collapse
No announcement yet.

Good bye LT-1....Helloooooo LS-1!

Collapse
X
Collapse
Who has read this thread:
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • ok. So I insrtalled the pcm and fired it up. I have a check engine light. s.o.b. none of the evap stuff got deleted. and I got p0327 frigin knock sensor code. Still runs like a scalded cat! Email sent to Frost. goonna go play!

    Comment


    • AWESOME!!!
      sigpic
      If you come across a cobra in the wild, wipe it off and apologize.

      Comment


      • lol! What a riot!!!!! Did a little goofing off on Gratiot, Roseville Gratiot cruise was today! Some nice cars out there, a few F bodys, good turn out. Ended way early though. I think I may have a bad shock in the front. tends to bounce a bit, not a fan. Runs cool, doesnt hit the first hash mark on the temp gauge, good oil pressure. Idles a shade over 40 psi. Will need to do some tweeks. exhaust hits the sub frame and x member. shocks, is there a way to put new bushings in the bottom of a front shock? The other set are good but the bushing is wasted. front alignment, airconditioning charge, knock sensors will have to be addressed Apparently you shouldnt wash an ls 1 engine, they dont like soggy knock sensors. Oh the evap crap in the tune. other than that its gettin there!
        Oh the Tach! forgot about the Tach.... Is there a fix for this? it reads way low, Idles about 300 and 50 mph is just below 1k. Thats not even close.

        Comment


        • just received an email from Steve @ Frost. He missed the evap codes cuz he was rushing to get it done for me before he left to go to Indiana for a tuning session. So I gotta send it back. oh well, so it goes. I am considering having him step up the trans shifting to the next level. Its pretty mellow if I am not in the skinny pedal , but if I am driving it hard it shifts pretty hard, breaks the wheel loose easily. I must dwell on this question for a while.
          She is getting her front end aligned and air conditioning charged tomorrow. Hopefully, there wont be any troubles.... there shouldnt be, but you never know.
          I need to bleed the brakes again, the rears had a loose fitting at the distribution block/ abs controller . I think I will keep her intact this weekend and ship it back on Monday. I need it for the Clinton twp cruise on the 3rd.

          Comment


          • Air conditioning is charged and front end is aligned. But, I didnt get home in time to pick it up.

            Comment


            • I might of saw you on Gratiot. I was out for a bit in the Challenger then in the Camaro.
              Originally posted by Yoshi94
              Mines about an inch bigger than Kyles. I need to get one of those
              Originally posted by ryanwarby01
              Put it this way, if you have a money tree a LT1 is a wood chipper!
              sigpic

              Comment


              • IMO the only way a trans should ever shift is firm. Not to the point its violent, but slipping clutches are never a good thing...
                -Joel
                1995 Z28 M6 - AI226/234 - autocross ricer
                1984 Scottsdale K10 - 305/4bbl/4spd


                WTB List:Midwest Chasis DS Loop

                Comment


                • FS. Love those old Mopars. There were quite a few nice cars out, my kneck was stiff by the end of the day. I think it should have run later though. Cruising durring the day is fine if you're old, I prefer it later in the day like when I was a kid, but its better than not cruising.I did prefer this to the East pount cruise though. The single lane stuff kinda sucked.

                  Comment


                  • Joel. Im leaning in that direction too. Im going to drivet it for the weekend and decide

                    Comment


                    • Originally posted by zeeman View Post
                      FS. Love those old Mopars. There were quite a few nice cars out, my kneck was stiff by the end of the day. I think it should have run later though. Cruising durring the day is fine if you're old, I prefer it later in the day like when I was a kid, but its better than not cruising.I did prefer this to the East pount cruise though. The single lane stuff kinda sucked.
                      To many cops were around. I'll be at my buddy's tattoo shop for a car show Saturday and then I'll be at the Clinton Twp Gratiot Cruise Sunday.
                      Originally posted by Yoshi94
                      Mines about an inch bigger than Kyles. I need to get one of those
                      Originally posted by ryanwarby01
                      Put it this way, if you have a money tree a LT1 is a wood chipper!
                      sigpic

                      Comment


                      • Ill be either @ m3 surplus on 15 and gratiot, or advanced auto, I have a spot at both places.

                        Comment


                        • Willing to sell the dash you're taking out of your purple car? lol I know I know im a pest
                          2002 Z28 Camaro A4
                          1993 Z28 Camaro M6- SOLD
                          1999 Z28 Camaro M6- SOLD
                          2008 Ford Fusion SE - DD
                          -- MCALUS MOLDED PILLAR PODS, PM ME FOR MORE INFO--
                          sigpic

                          Comment


                          • If he doesn't want to, I have an extra 94 dash (not the pad)
                            1994 Z28 - 2002 M3 - 2015 1.0T Mileage Accumulator

                            sigpic

                            Comment


                            • Originally posted by landstuhltaylor View Post
                              If he doesn't want to, I have an extra 94 dash (not the pad)
                              Looking to upgrade to the 97-02 dash. Thanks tho!
                              2002 Z28 Camaro A4
                              1993 Z28 Camaro M6- SOLD
                              1999 Z28 Camaro M6- SOLD
                              2008 Ford Fusion SE - DD
                              -- MCALUS MOLDED PILLAR PODS, PM ME FOR MORE INFO--
                              sigpic

                              Comment


                              • I will Mike, but its not complete. No cluster, heater controls or upper dash pad. The real problem is when. I am not ready to do the swap yet. Itay be a while, if you want to wait Ill give it to you for 50 I think I have all the heater ducting too.
                                Dont waste a trip, I still have those seats you wanted. Pm me for a package price.

                                Comment

                                Working...
                                X