Cam and valvetrain

[DETROITMUSCLE]

Time to try and recoupe some of the cost of the cam install so I have a couple of things up for sale.

LPE GT2-3 cam used approximatly 6K miles
LS6 springs (yellow ones) 3K miles
Comp cams hardened 7.425" pushrods 3K miles

I'd like to sell these three as a package for $300 and I can even throw in a spring compressor tool needed to change the spring out. These pushrods are the required size for stock heads. This cam should run fine on a stock tune, and has a idle that is very stock sounding.

Trend 7.300" pushrods used 3K miles
$60

If for some reason you want some of the parts seperate let me know and we can work something out.

[1BADAIR]

might be interested in the 7.425's Have to check which ones I need though

[Keego Ridah]

What are the specs on that cam?

[99TransAmWS6]

What is the stock pushrod length? I need a hardned set

[Superman09]

join the club, lol. Stock is 7.400 i believe, he doesnt have any otherwise they'd be in my garage right now, lol

[shiftinda93z]

Is that the cam that's good for boost if i remember correctly? I'm definatly looking for one of them, can you at least PM me the specs, and did you run those push rods with stock heads? Use the cam with boost, etc?

[DETROITMUSCLE]

cam specs are 207/220 573/.580 at 118 LSA
The cam would do very well in a boosted application which is what I was planning but now I'm going a different route. I never ran the cam on boost only motor and I was pleased with the way it performed for being so mild. The springs and pushrods will both work on stock heads and are the required valvetrain for the cam.

[wezeles]

what is it with you ls1 guys all these big lifts but no durration cams... its a roller block come on..lol i ran that much on my old block then switched off flat tappet to get more durration opening a valve more helps a bit but keeping it open longer is what gets ya moving...

[1BADAIR]

his new cam is like 239 242 duration, The cam he is selling is a stealth blower cam.

My cam is 246 248 .615 switching to a 250 257 .630< idles like stock

[bandit_ad22]

what did this make on the dyno??? or et time??

[DETROITMUSCLE]

With my setup I made 345rwhp on a mustang dyno unlocked and ran a best of 12.55 at 114mph with a shitty ass 2.0 60'

[bandit_ad22]

do u have an auto or 6sp and what gears where u ringing in ur car?

[DETROITMUSCLE]

my car is an auto with a 3500 stall and stock 3.23 gears.

[DETROITMUSCLE]

bump, also adding this to LS1tech because I need the cash.

[DETROITMUSCLE]

Your serious? If your for real its yours for sure.