Meissen's LT1 Rebuild Thread

[Old Fart]

I'm looking forward to hearing your car run again Brian. So if not at the M&G then perhaps the westside summer activities.

[Kwazrollinz28]

5th Annual MiFbody Meet & Greet 2009 Countdown:
16 Days, 14 Hours
50 Minutes, 28 Seconds.

This part scares me i can finish my car this week but getting the bugs out is the hard part.
so should i sign up or what?

[phoenix_rising]

Yes please

[meissen]

5th Annual MiFbody Meet & Greet 2009 Countdown:
16 Days, 14 Hours
50 Minutes, 28 Seconds.

This part scares me i can finish my car this week but getting the bugs out is the hard part.
so should i sign up or what?

Yeah man - would rather print the registration out and then you not show up than not have the registration ready and force you to fill it out when you get there.

[bigjon88]

come on b get on there asses and crack the whip to get ur motor back....

[Kwazrollinz28]

Yeah man - would rather print the registration out and then you not show up than not have the registration ready and force you to fill it out when you get there.

alright i'll do it, Im working my ass off to get this car done, but my dad keeps dragging me down by procrastinating Really bad.

It shouldn't take me long i will be done with this car this weekend, now i just need 80 dollars for a tune, and then gas for some 94 fuel for the car to get to bakers and a few test runs.

[98blackbeauty]

I'm looking forward to hearing your car run again Brian. So if not at the M&G then perhaps the westside summer activities.

I'm sure we'll have it done and running by 7/18 The Summer M & G.

[bumpin_z]

Summer M&G?

[meissen]

There's a summer M&G at the Gilmore Car Museum July 17th. Check out the Summer M&G forum for more information.

[MP81]

So you guys think it might be done by the Summer M&G?

[meissen]

Hope so - once the M&G is over then I can start saving my money to pay for it.

[MP81]

Hope so - once the M&G is over then I can start saving my money to pay for it.

Yeah, I understand. Lots of stuff going on, prepping for the M&G and what not. In time, young grasshopper.

[MiDi_2001]

Are you rebuilding your existing setup; meaning, utilizing the same block?

[meissen]

Yessir - it's essentially done... but I have to save up some $$. Cylinders were bored 040 over because he was able to get 040 pistons faster than 030. Crank was welded and line bored 20/20. So I now have a 357ci.

[Kwazrollinz28]

Yessir - it's essentially done... but I have to save up some $$. Cylinders were bored 040 over because he was able to get 040 pistons faster than 030. Crank was welded and line bored 20/20. So I now have a 357ci.

bastard.

I can't wait for big bucks and build a 396LT1 screw these LS1's im sticking with the underdogs, I kick LS1 ass no problem anyhow.