Announcement

Collapse
No announcement yet.

choosing the right cd player

Collapse
X
Collapse
Who has read this thread:
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #61
    I'd run 2 way in the dash for a clearer sound. 3-ways have to push bass out of them.

    Comment


    • #62
      Originally posted by Chicklet View Post
      http://www.cardiscountstereos.com/SpeakerGuide23.asp = 4X6" dash

      So far I haven't been able to find 4x6 3-ways. I found 5-way 6x9"s! From what I see though the other 2 ways are for the tweeters. I did some research and anything higher than 3-way is irrelevant in most cases because how often do you have music with super high-pitch noises?
      I knew 5.25" didn't sound right, I dunno why the hell I kept thinking that, I knew they were 4x6s...oh well.

      Yeah, exactly what Mark said, only run 2-way front speakers.

      And since you'll wanna run 3-ways in the back, set the fade one or two notches to the back, to put less strain on the front speakers. It'll sound much better.
      Gone but not forgotten: 1986 Chevrolet Camaro IROC-Z

      "You shall ride eternal. Shiny and chrome."

      Comment


      • #63
        I don't know how tight those 4 by 6's are in the dash, but if there is any room at all i would suggest going with a 6.5" speaker. They have better sound output than most 4x6's you will find, but again i don't know how much room your working with. When looking for speakers look for a set that have a really low and high frequency response, and always remember the higher the db number the louder they will get with less power. If you take a speaker that has a db rating of 85 and a speaker with a rating of 90db and feed them the same power, the 90db speaker will sound much louder. Also if you are planning to just run them off of the cd player power, look for speakers that have an rms value of around 50 watts, because otherwise you will never power the speakers enough to see their true potential. Hope this helps out, if you have any questions alot of times www.sounddomain.com has a pretty good forum with some good stickies on audio equipment.
        sigpic
        2002 Camaro v6: Cobalt metalic blue
        "Blue Devil"
        Alpine cda-9851, 2- RE 6.5" component sets, 1 RE sx15" subwoofer, 1 Alpine MRV 1005d amplifier, Knuconcpets rca's, Memphis audio wiring, and 100 sq ft of FAT MAT extreme... got for 147 db at the windshield before fat mat new numbers soon to come.

        Comment


        • #64
          When it comes to room: there's not much...They're basically where the dash meets the windshield...though you might be able to fit a bigger speaker up there with modifications to the dash pad and the brackets for the speakers...
          Gone but not forgotten: 1986 Chevrolet Camaro IROC-Z

          "You shall ride eternal. Shiny and chrome."

          Comment


          • #65
            Originally posted by cobalt camaro View Post
            I don't know how tight those 4 by 6's are in the dash, but if there is any room at all i would suggest going with a 6.5" speaker.
            Also if you are planning to just run them off of the cd player power, look for speakers that have an rms value of around 50 watts, because otherwise you will never power the speakers enough to see their true potential.
            The depth of the dash speakers on a 3rd gen is 1.75" which the 6.5"s seem to have, but I'm cool with the 4x6"s.
            Thanks for the info! I need all I can get! I'm pretty ingnorant when it comes to electronics, but I'm learning!

            The total or per speaker?

            Originally posted by MP81 View Post
            When it comes to room: there's not much...They're basically where the dash meets the windshield...though you might be able to fit a bigger speaker up there with modifications to the dash pad and the brackets for the speakers...
            Yeah, not really into modifying anything...just adds to the cost, you know.
            Last edited by Chicklet; February 20th, 2009, 09:02 AM.
            Bingo Bangle Jewelry Design
            http://bingobangle.synthasite.com/



            sigpic

            Comment


            • #66
              Originally posted by Chicklet View Post
              I did some research and anything higher than 3-way is irrelevant in most cases because how often do you have music with super high-pitch noises?
              I knew you could figure it out

              Now I know who to call for my stuff if I need it



              VicePresident of West Michigan Firebird Club
              A.K.A The Maverick
              http://www.cardomain.com/ride/660128/1
              93 TA Currently Under Construction AGAIN
              2007 2500 Chevy Silverado Crew Cab w/ 6.0L & 3.73's

              Comment


              • #67
                Originally posted by Chicklet View Post
                Yeah, not really into modifying anything...just adds to the cost, you know.
                Yep, I understand fully!

                The 4x6s will sound just fine. I was very happy with mine.
                Gone but not forgotten: 1986 Chevrolet Camaro IROC-Z

                "You shall ride eternal. Shiny and chrome."

                Comment


                • #68
                  Originally posted by Phantom383 View Post
                  I knew you could figure it out

                  Now I know who to call for my stuff if I need it
                  Yep! I know it all, and if I don't know - I'll find out!

                  Originally posted by MP81 View Post
                  Yep, I understand fully!

                  The 4x6s will sound just fine. I was very happy with mine.
                  Sweet, thanks.


                  I'm moving April 4th, so I'm not going to buy anything until mid-April, but it's always goog to get started when ya can.
                  Bingo Bangle Jewelry Design
                  http://bingobangle.synthasite.com/



                  sigpic

                  Comment


                  • #69
                    that wattage is per speaker, but if you buy an external amp you can go higher, and you will have much better sound. Your internal amp on your cd player has quite a bit of distortion and does not have the capability to make good "clean" power. It's totally up to you, if your used to stock buying new speakers and a cd player will sound incredible.
                    sigpic
                    2002 Camaro v6: Cobalt metalic blue
                    "Blue Devil"
                    Alpine cda-9851, 2- RE 6.5" component sets, 1 RE sx15" subwoofer, 1 Alpine MRV 1005d amplifier, Knuconcpets rca's, Memphis audio wiring, and 100 sq ft of FAT MAT extreme... got for 147 db at the windshield before fat mat new numbers soon to come.

                    Comment


                    • #70
                      Yeah, in my dad's van, he's running an Alpine headunit, utilizing only the pre-outs, and goes into a 6-channel A/D/S amp, with A/D/S door speakers and tweeters, and a pair of Kicker 6" subs behind the seats. Needless to say, the system sounds GREAT. Drowns out the sound of how shitty his truck runs...
                      Gone but not forgotten: 1986 Chevrolet Camaro IROC-Z

                      "You shall ride eternal. Shiny and chrome."

                      Comment


                      • #71
                        Originally posted by cobalt camaro View Post
                        that wattage is per speaker, ...if you're used to stock buying new speakers and a cd player will sound incredible.
                        Awesome. It was confusing me on ebay when it said RMS 90 then down in the spec area it said 45. Why do they write "90" when it's not really 90?

                        [quote=MP81;390255] goes into a 6-channel A/D/S amp, with A/D/S door speakers quote]

                        What are channels? My receiver (that I'm gonna buy) has 4 channels. Not sure what that means.
                        What is the A/D/S???
                        Bingo Bangle Jewelry Design
                        http://bingobangle.synthasite.com/



                        sigpic

                        Comment


                        • #72
                          Channels...

                          Stereo is two channel, left and right.

                          That's odd, it said RMS 90W and the 45W down somewhere? Should be the other way around. Generally, RMS is what it can sustain for longer periods (usually what is advertised - for example, my amplifier that I have is 1000W Max, but it's only about 460W RMS) wattage handling.

                          http://ezinearticles.com/?RMS-Power-...ower&id=481475

                          A regular head unit is four channel.

                          Front left, front right, left rear, right rear.

                          A/D/S was a brand. They made some AWESOME shit, but I believe the dissolved recently.
                          Last edited by MP81; February 20th, 2009, 02:03 PM.
                          Gone but not forgotten: 1986 Chevrolet Camaro IROC-Z

                          "You shall ride eternal. Shiny and chrome."

                          Comment

                          Working...
                          X