Announcement

Collapse
No announcement yet.

Parting Out 1999 Trans Am - Mecham Hood, T-tops, (engine/transmission not available)

Collapse
X
Collapse
Who has read this thread:
 
  • Page of 4
  • Filter
  • Time
  • Show
Clear All
new posts
Previous 1 2 3 4 template Next
  • #31
    Where the wires were sheared/cut:
    IMAG0033[1].jpg

    This is the end I need:
    IMAG0034[1].jpg

    1998 Camaro Z28 - Bright Red, 6.0 TR224, 4l60e, 3.42 Eaton TrueTrac
    1989 Camaro IROC-Z Convertible - 355 big tube TPI, WC T5, 3.42 Zexel Torsen, CTS-V/C4 brakes
    1955 Bel Air 2 Door Post - 357 TPI, Muncie M20, 4 wheel disc

    2006 Saab 9-7x 5.3i Daily Driver

    Comment

    • #32
      bump!


      1998 Camaro Z28 - Bright Red, 6.0 TR224, 4l60e, 3.42 Eaton TrueTrac
      1989 Camaro IROC-Z Convertible - 355 big tube TPI, WC T5, 3.42 Zexel Torsen, CTS-V/C4 brakes
      1955 Bel Air 2 Door Post - 357 TPI, Muncie M20, 4 wheel disc

      2006 Saab 9-7x 5.3i Daily Driver

      Comment

      • #33
        Originally posted by hoogiesngrinderz View Post
        bump!

        Sorry I didn't see your pictures. So you want the pigtail that runs down the fender well from the body harness? I assume you want it cut close the fender(where the branches off)?

        Comment

        • #34
          No biggy, it's not like the car is going anywhere

          And yes, as close to the three connectors on the passenger fender well as possible. I was going to buy the connector, but then I would have had to buy a secondary lock, a minimum of 10 terminals, 10 cable seals, wire, wind it, etc...

          How much would you like for that chunk of harness?

          1998 Camaro Z28 - Bright Red, 6.0 TR224, 4l60e, 3.42 Eaton TrueTrac
          1989 Camaro IROC-Z Convertible - 355 big tube TPI, WC T5, 3.42 Zexel Torsen, CTS-V/C4 brakes
          1955 Bel Air 2 Door Post - 357 TPI, Muncie M20, 4 wheel disc

          2006 Saab 9-7x 5.3i Daily Driver

          Comment

          • #35
            Originally posted by hoogiesngrinderz View Post
            No biggy, it's not like the car is going anywhere

            And yes, as close to the three connectors on the passenger fender well as possible. I was going to buy the connector, but then I would have had to buy a secondary lock, a minimum of 10 terminals, 10 cable seals, wire, wind it, etc...

            How much would you like for that chunk of harness?
            $10-$15 shipped
            Just PM me your address and I will get it shipped and we will worry about money later

            Comment

            • #36
              Do you have the steering wheel? If so how much do you want for it?
              95 T/A m6, cc503, harland sharp 1.6 rr, long tube pacesetters wrapped, 3" cutout, K&N, Moog suspension

              Comment

              • #37
                Originally posted by Bentley View Post
                Do you have the steering wheel? If so how much do you want for it?
                Yes I have two actually. $30
                One is listed on ebay item number 360824951005

                Comment

                • #38
                  would you be available Friday? Also I take it the wheel will fit in a 95 T/A? I don't see why it wouldn't but I've never replaced a steering wheel
                  Last edited by Bentley; January 16th, 2014, 02:09 AM.
                  95 T/A m6, cc503, harland sharp 1.6 rr, long tube pacesetters wrapped, 3" cutout, K&N, Moog suspension

                  Comment

                  • #39
                    Originally posted by Bentley View Post
                    would you be available Friday? Also I take it the wheel will fit in a 95 T/A? I don't see why it wouldn't but I've never replaced a steering wheel
                    Yes and the wheels are located in Madison Heights. To my knowledge it will but I would double check

                    Comment

                    • #40
                      trans cable from shifter ?
                      '91 Camaro Modded, LSx, House of Kolor Intense White, lowered, GS chrome 18" wheels, 14" Brembo CTS-V on all 4 corners, LS rear end, FP suspension components

                      " When in doubt...throttle out ! "
                      ENVYsion Entertainment Group

                      Comment

                      • #41
                        Originally posted by Gregs_gsxr View Post
                        trans cable from shifter ?
                        It was a 6 speed manual.

                        Comment

                        • #42
                          Engine and Transmission SOLD!

                          Comment

                          • #43
                            headlights? probably already sold
                            ASE Certified Automatic Transmission Mechanic

                            I would rather push a Chevy than drive a Ford

                            Remember folks stop lights timed for 35mph are also timed for 70mph.

                            94 Camaro Z28 LT1 396 sigpic

                            Comment

                            • #44
                              Originally posted by M_Juntti View Post
                              headlights? probably already sold
                              Only headlight part I have is listed on ebay item number 360837244359
                              Last edited by meissen; January 21st, 2014, 06:10 PM.

                              Comment

                              • #45
                                damn, they are so hard to find... for a good price anyway lol. thanks though
                                ASE Certified Automatic Transmission Mechanic

                                I would rather push a Chevy than drive a Ford

                                Remember folks stop lights timed for 35mph are also timed for 70mph.

                                94 Camaro Z28 LT1 396 sigpic

                                Comment

                                Previous 1 2 3 4 template Next
                                Working...
                                X