ive got a 1995 trans am, mods are as follows
Bored 0.030 over
flat top pistons
eagle crank
eagle rods forged NOT cast
1.6RRS
custom gm cam
ported intake
ported intake side of heads
ported throttle body area of intake, will take upto a 58mm
throttle body air foil
msd opti 2 months old
msd coil 2 weeks old
autolite plug wires 2 months old
platnum plugs 2 months old
ac delete pully 2 months old
high volume ported oil pump
1LE style Aluminum intake elbow
descreened MAF
K&N cold air intake
42LB Green giant injectors
pacesetter longtubes
offroad y pipe
magnaflow muffler
PCM for less tune (could use a good dyno tuning)
new TPS
new OIL pressure sensor
as for the transmission
4L60E auto
Beast sunshell
kevlar band
kevlar clutches
drilled corvette servo
vigilanti 2500 stall
high volume front pump
full B&M stage 2 shift kit
umi trans mount in black
engergy syspension tourqe arm bushing
rear end is out of a firehawk
373 gears
strange axles,
posi unit and it does work
could use new brakes
paint
and alittle body work
in pics below youll see a y pipe next to the car, that was the factory y pipe for the manifolds, i had 3 o2s on this car once i took the car and had the y pipe installed the 3rd o2 at the cat was deleted, so now the service engine soon light is on, still has 2 o2s in place with extenstions for the longtubes, pics was simply to prove that fact.
Bored 0.030 over
flat top pistons
eagle crank
eagle rods forged NOT cast
1.6RRS
custom gm cam
ported intake
ported intake side of heads
ported throttle body area of intake, will take upto a 58mm
throttle body air foil
msd opti 2 months old
msd coil 2 weeks old
autolite plug wires 2 months old
platnum plugs 2 months old
ac delete pully 2 months old
high volume ported oil pump
1LE style Aluminum intake elbow
descreened MAF
K&N cold air intake
42LB Green giant injectors
pacesetter longtubes
offroad y pipe
magnaflow muffler
PCM for less tune (could use a good dyno tuning)
new TPS
new OIL pressure sensor
as for the transmission
4L60E auto
Beast sunshell
kevlar band
kevlar clutches
drilled corvette servo
vigilanti 2500 stall
high volume front pump
full B&M stage 2 shift kit
umi trans mount in black
engergy syspension tourqe arm bushing
rear end is out of a firehawk
373 gears
strange axles,
posi unit and it does work
could use new brakes
paint
and alittle body work
in pics below youll see a y pipe next to the car, that was the factory y pipe for the manifolds, i had 3 o2s on this car once i took the car and had the y pipe installed the 3rd o2 at the cat was deleted, so now the service engine soon light is on, still has 2 o2s in place with extenstions for the longtubes, pics was simply to prove that fact.


Comment