Announcement

Collapse
No announcement yet.

GI: 1995 Camaro Z28 6 speed

Collapse
X
Collapse
Who has read this thread:
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • GI: 1995 Camaro Z28 6 speed

    Want to see if anyone is interested in buying my car. If its gonna happen, it needs to happen fast. Others can vouch, this is an extremely clean LT1 car.

    1995 Camaro z28
    91k miles
    I have the owners manual, tape, window sticker, and other original documentation from the car. I am the 2nd owner, and the car has been VERY taken care of.

    Condition:
    JUST rebuilt t56- ~1500 miles on the rebuilt trans. Was built by Liberty's Gears. Had the stage II package installed, which Tick Performance warranties to 600 ft/lbs if torque. At this time a stock replacement clutch was put in as well.

    • Bronze 1-4 Fork Pads
    • OEM 5-6 & Reverse Fork Pads
    • Billet 3-4 Synchronizer Keys (with upgraded springs)
    • New OEM 1-2, 5-6 & Reverse Keys & Springs
    • Carbon Fiber Synchronizer (blocker) Rings
    • Steel 3-4 Shift Fork
    • New 1-2 Synchronizer Assembly
    • New 3-4 Synchronizer Assembly
    • New Front Seal
    • New Rear Seal

    Opti-spark, Ac Delco Plugs and Wires, MSD Coil all done 5,000 miles ago

    Fuel pump was done at 65k miles. Since then it has not been ran below 1/4 tank of gas

    Options:
    Leather
    Bose Surround Sound
    Drivers Power Seat
    Power Windows
    Power Locks
    T-tops
    Great AC
    Great Heat

    Mods:
    K&N Cold Air Intake System
    Drilled and slotted Rotors all the way around with ceramic pads.
    Edelbrock Weld in Sub Frame Connectors
    Dyno-Max Muffler- Sounds Great, Flows awesome, and is fairly quiet. I would compare it to a Magnaflow
    Sealed beam conversion kit from Eurolamps, with Bi-xenon bulbs, very white light.
    Ls1 Aluminum Driveshaft
    Clear Front and Rear Marker lights with correct colored bulbs

    Issues with the car:

    Low oil light is on. The sensor is bad, it just needs replaced.

    Drivers window switch clip is broken, so the switch plate doesn't sit quite flush. Not very noticeable.

    The rims on the car are Milla Miglia 1000. The are 17x9.5 all the way around. Very rare rims for an F-body, never seen another one with them. Two of them are very slightly bent, (a common issue with them). There is nothing unsafe about them, they just make the car vibrate a little bit at higher speeds. I would compare it to the feeling of an LT1 Steel Driveshaft. Most wouldn't even notice it, but I want to be completely honest here.

    The 17" rims need tires all the way around.

    I do currently have Salad Shooters with Blizzaks on the car.











    Does now have dual 3" chrome tips out the rear





    Again, one of THE cleanest LT1 F-bodys around. I have nothing to hide, I will answer any question, take any extra picture needed. I'm looking to get $5,000 obo. Don't be afraid to make an offer. Will post interior pictures later, but there isn't much to see, its a mint condition stock interior.
    Last edited by my95z28; December 18th, 2009, 06:18 PM. Reason: Changed a picture

    2011 Mustang GT
    20" Satin Black AMRs with 305/35 & 275/35 MT Street Radials, Saleen Grille, CS Lower Valance, Roush Axleback, GT500 Spoiler, resonator delete

    In Progress: Brembo 6-piston brake upgrade



  • #2
    sorry to see you selling it. I've been REALLY thinking of getting another LT1 just to really cruise around in... this seems like a pretty good option.

    EDIT: I'll call you this weekend about it

    Comment


    • #3
      damn man amazing looking car. and maybe i missed it but how much you trying to get out of her? wanna trade for a V6? lol jp
      94 V6 A4>>>>LT1 M6>>>>>>383 M6 13.1 @ 109 2.2 60' Sold/Stripped
      94 Z28 383 LT1 A4 SNAPPED CRANK
      1992 Camaro RS 305 700r4 Convert.
      1986 Dodge Ramcharger 318 Dually Rear, Camo paint. Scrapped
      1993 s10 4x4 5spd 4.3 on 31s awaiting a lift. [COLOR=rgb(0,0,0)]traded for...[/COLOR]
      1998 Jeep Grand Cherokee 4.0 I6 getting 3in lift and 31s within a week or two
      "Life is full of decisions, You make them and don't look back"

      Comment


      • #4
        Nice car, good price, it shouldn't last long. I saw two different exhaust tips..Does it currently have the square or round tips? Just curious.
        Last edited by 01CAMAROSS; December 18th, 2009, 07:27 PM.
        sigpic

        Comment


        • #5
          PLEASE PLEASE SOMEONE BUY THIS!!!

          Kyle is always worrying about the car being clean enough for my acceptance when he is around me - and i always think its perfect.

          This is about the most f-body for the money I've ever seen.
          -Joel
          1995 Z28 M6 - AI226/234 - autocross ricer
          1984 Scottsdale K10 - 305/4bbl/4spd


          WTB List:Midwest Chasis DS Loop

          Comment


          • #6
            Im sad to see it go, but I completely understand.
            1998 Chevrolet Camaro Z28 - 6 Speed

            Comment


            • #7
              Originally posted by ThreeHonks View Post
              sorry to see you selling it. I've been REALLY thinking of getting another LT1 just to really cruise around in... this seems like a pretty good option.

              EDIT: I'll call you this weekend about it
              Make sure you do if you are interested, I'm trying to make something happen fast, I would much rather let someone on here have it than the dealer.

              Originally posted by 1slo_camaro View Post
              damn man amazing looking car. and maybe i missed it but how much you trying to get out of her? wanna trade for a V6? lol jp
              Sorry going to have to say no on the v6. Looking to get $5000 or best offer.
              Originally posted by 01CAMAROSS/SLP View Post
              Nice car, good price, it shouldn't last long. I saw two different exhaust tips..Does it currently have the square or round tips? Just curious.
              The pics with the rectangle tips are the stock, then I added the Dynomax muffler and 3" chrome tips that are pictured. Car has dynomax muffler.


              Thanks for the kind words guys, I know for a fact that I will miss this car this summer, just hope I don't regret selling it.

              2011 Mustang GT
              20" Satin Black AMRs with 305/35 & 275/35 MT Street Radials, Saleen Grille, CS Lower Valance, Roush Axleback, GT500 Spoiler, resonator delete

              In Progress: Brembo 6-piston brake upgrade


              Comment


              • #8
                Thanks for the kind words guys, I know for a fact that I will miss this car this summer, just hope I don't regret selling it.

                Even though you know that you are going to regret it...not to hijack but what are you getting to replace it
                burn rubber!

                Comment


                • #9
                  Originally posted by my95z28 View Post
                  Make sure you do if you are interested, I'm trying to make something happen fast, I would much rather let someone on here have it than the dealer.
                  ryan is trying to get ahold of you right now
                  -Joel
                  1995 Z28 M6 - AI226/234 - autocross ricer
                  1984 Scottsdale K10 - 305/4bbl/4spd


                  WTB List:Midwest Chasis DS Loop

                  Comment


                  • #10
                    I left you a txt and voicemail kyle. call me at 248-660-3174

                    Comment


                    • #11
                      would you take 4000$ cash?
                      HISTORY OF CARS PAST AND PRESANT (none of them were wrecked)

                      1989 S10 standard with 350 carb'd, th350, shift kit, shorties, 600cfm, hooker TD's, 3.23 non posi, B&M shifter(sold)

                      1991 firebird with t-tops and 3.1L, 700r4, 3.23 non posi, flowmaster cat back, 15ibs injectors, (sold)

                      1991 formula with t-tops, WS6, 5.0TPI, WC T5. 3.42 posi. magnaflow cat back, 52mm TB, and hurst billet (sold)

                      1994 camaro z28 with t-tops, 5.7LT1, T56, 3.42 posi. CAI, elbow, Airfoil, SFC, STB, pro 5.0, flowmaster cat back. (sold)

                      2000 Trans am with t-tops, 5.7LS1, T56, 3.42posi, LT'S, ORY, magnaflow, lid, lingenfelter intake, 3pt SFC, STB, LCA, (current)

                      Comment


                      • #12
                        Originally posted by JoeliusZ28 View Post
                        ryan is trying to get ahold of you right now
                        Originally posted by ThreeHonks View Post
                        I left you a txt and voicemail kyle. call me at 248-660-3174
                        Sorry fellers, I was at work. Thanks for the help Joel.


                        Originally posted by scoutsniper View Post
                        would you take 4000$ cash?
                        I'm going to have to say no for now, thats a bit lower than I am willing to accept at his moment.

                        2011 Mustang GT
                        20" Satin Black AMRs with 305/35 & 275/35 MT Street Radials, Saleen Grille, CS Lower Valance, Roush Axleback, GT500 Spoiler, resonator delete

                        In Progress: Brembo 6-piston brake upgrade


                        Comment


                        • #13
                          send me a msg with your bottom line. and ill see if i can work with it.

                          thanks. beautiful car.
                          HISTORY OF CARS PAST AND PRESANT (none of them were wrecked)

                          1989 S10 standard with 350 carb'd, th350, shift kit, shorties, 600cfm, hooker TD's, 3.23 non posi, B&M shifter(sold)

                          1991 firebird with t-tops and 3.1L, 700r4, 3.23 non posi, flowmaster cat back, 15ibs injectors, (sold)

                          1991 formula with t-tops, WS6, 5.0TPI, WC T5. 3.42 posi. magnaflow cat back, 52mm TB, and hurst billet (sold)

                          1994 camaro z28 with t-tops, 5.7LT1, T56, 3.42 posi. CAI, elbow, Airfoil, SFC, STB, pro 5.0, flowmaster cat back. (sold)

                          2000 Trans am with t-tops, 5.7LS1, T56, 3.42posi, LT'S, ORY, magnaflow, lid, lingenfelter intake, 3pt SFC, STB, LCA, (current)

                          Comment


                          • #14
                            Originally posted by chevyman9306 View Post
                            Thanks for the kind words guys, I know for a fact that I will miss this car this summer, just hope I don't regret selling it.

                            Even though you know that you are going to regret it...not to hijack but what are you getting to replace it
                            Sorry, accidentally skipped right over this. Trying to find something AWD and 4 cylinder. Probably a Subaru Impreza or something.

                            Originally posted by scoutsniper View Post
                            send me a msg with your bottom line. and ill see if i can work with it.

                            thanks. beautiful car.
                            Pm sent

                            2011 Mustang GT
                            20" Satin Black AMRs with 305/35 & 275/35 MT Street Radials, Saleen Grille, CS Lower Valance, Roush Axleback, GT500 Spoiler, resonator delete

                            In Progress: Brembo 6-piston brake upgrade


                            Comment


                            • #15
                              See ya tomorrow Kyle! hopefully I have it off your hands in a few days

                              Comment

                              Working...
                              X