Announcement

Collapse
No announcement yet.

new from Fair Haven, MI need someone to help with car

Collapse
X
Collapse
Who has read this thread:
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    welcome...any luck for finding the vac leak?
    '91 Camaro Modded, LSx, House of Kolor Intense White, lowered, GS chrome 18" wheels, 14" Brembo CTS-V on all 4 corners, LS rear end, FP suspension components

    " When in doubt...throttle out ! "
    ENVYsion Entertainment Group

    Comment


    • #17
      for the input and the welcome.....i actually haven't been able to i just got home from work but i went out to tinker on it and my battery is comepletely dead.......guess i cranked too much....i gotta get a new one then continue playing with it I'll update some more this evening....thanks again

      Comment


      • #18
        alright well i got the battery put in and i tried to plug the vac line like one of the ideas that was sent......that didnt work.......would the high idle be caused from the push rods not being adjusted properly?

        Comment


        • #19
          push rods wouldnt have any influence on the idle, try the carb cleaner thing around the injectors and vac lines
          '91 Camaro Modded, LSx, House of Kolor Intense White, lowered, GS chrome 18" wheels, 14" Brembo CTS-V on all 4 corners, LS rear end, FP suspension components

          " When in doubt...throttle out ! "
          ENVYsion Entertainment Group

          Comment


          • #20
            alright well i sprayed all over in spurts and when i sprayed over by the front driver side injector it picked up rpms.......i swear its seated all the way in and everything is tightened down so idk what it could be

            Comment


            • #21
              could be a bad O ring seal on the injector itself... but at least you have the area the problem is coming from
              '91 Camaro Modded, LSx, House of Kolor Intense White, lowered, GS chrome 18" wheels, 14" Brembo CTS-V on all 4 corners, LS rear end, FP suspension components

              " When in doubt...throttle out ! "
              ENVYsion Entertainment Group

              Comment


              • #22
                Welcome to the site. Good luck getting your vacuum leak figured out.. Sounds like you may have found it!
                sigpic
                U.S. Army 1983-2005
                11.20@122.37 1.51 60'

                Originally posted by WMCCjames

                "Plans Subject to change upon Sobering up"

                Comment


                • #23
                  i just replaced the injector o-rings when i tore it apart the last time......

                  Comment


                  • #24
                    might as well double check
                    '91 Camaro Modded, LSx, House of Kolor Intense White, lowered, GS chrome 18" wheels, 14" Brembo CTS-V on all 4 corners, LS rear end, FP suspension components

                    " When in doubt...throttle out ! "
                    ENVYsion Entertainment Group

                    Comment


                    • #25
                      still thinking someone should come out lol.......everryone knows this better than me i wish someone could come out and help me i mean it may be safeish to drive somewhere but idk if i want to risk it

                      Comment


                      • #26
                        i would pull the injector back out and inspect it just to be sure it didnt get damaged on install,then put the injector back in.

                        Comment


                        • #27
                          is there a way to take the injector out without removing the upper intake on the 3.4?

                          Comment


                          • #28
                            ok so i felt ballzy and took my car around the block.....it has like no throttle response whatsoever.....it seemed to only move due to the high idle......but it would rev up when you hit the gas just not take off or anything......if you didnt have your foot on the gas for anything over like 8 seconds the car would die........I am sooooo clueless on this car idk how replacing the intake gasket would cause all this shit to happen

                            Comment


                            • #29
                              Was the vacuum line in the back still unplugged?
                              - Brian Meissen
                              Owner, MiFBody.com
                              Administrator, LTxTech.com


                              1994 Camaro LT1 Transplant - 357ci LT1, cammed, stalled, and driven.
                              2022 Camaro LT1 - "Cherry Bomb 2"
                              Michigan FBody Meet & Greet Car Show 2022
                              June 4th, 2022 - 9am to 3pm!!!
                              The HUB Stadium, Auburn Hills, MI

                              Comment


                              • #30
                                yeah but i dont know where it goes now can i see anything back there with the ac system in the way.....

                                Comment

                                Working...
                                X