Lower front A arm bushings?

[MeenZ28]

Anyone ever replace them? How hard of a task is it? When the arm is removed should they give up without much struggle or am I going to need a machine shop to "press" them out?

[Gregs_gsxr]

depends on how rusted your arms are. I had no issues when I pressed them out, on another set the arms just bent and pinched because they were too far gone.

[MeenZ28]

I doubt the rust will be a big issue. Jessica is a California car born and raised so I'm not worried. But even if there's no rust, will they still need to be pressed out or will a swift blow from a hammer (or similar) do the job?

[Gregs_gsxr]

i would say press will make easy work of it

[MeenZ28]

Ok, just want to make sure I know what to expect with it. Thank you.

[nektogen]

Great