Project: PBR-Built Z/28

[nascarnate326]

Looks good man.

Whens the test drive?

[JoeliusZ28]

She ran today! Turned the key, lit right off. No leaks, no problems!

[OIF1VET]

She ran today! Turned the key, lit right off. No leaks, no problems!

[JoeliusZ28]

Started fastening the lines up, going to have to finish this next weekend

[Fox Slaughter]

Screw you. Your car starts and I drop a trans on my head. What kind of crap is this?

[OVRKILL]

She ran today! Turned the key, lit right off. No leaks, no problems!

Congrats! So you don't need those harnesses?

[JoeliusZ28]

Congrats! So you don't need those harnesses?

Those are for the 24x conversion, which is looking like its going to be a project for next winter since its not "needed," whereas most of the other stuff im working on was long overdue. Unless i get bored and tackle it over summer

[Schuby87]

Project: PBR-Built Z/28

The lines look good! Hopefully everything went smooth with the install.

[JoeliusZ28]

The lines look good! Hopefully everything went smooth with the install.

Its all great! If you use my measurements for any other customers defintely take a few inches off at the sender, i have more line than i need.

[JoeliusZ28]

Kicking this project into high gear! Insurance is on the car and ive got 3 boxes waiting at home.

[MENTION=3929]dawdaw[/MENTION] - when you had your alt relocation on your car did you have to modify any wiring to reach the new location?

[birdie2000]

I used a kit that relocates the alternator in the same place, and I had to extend the small wire for the alternator that goes to the clip-on connector (not the actual alternator power wire). YMMV.

[JoeliusZ28]

Thanks! If i remember right thats just one or two wires so should be pretty straight forward

[birdie2000]

Yeah, I think mine was only one. It's really straightforward.

[dawdaw]

Kicking this project into high gear! Insurance is on the car and ive got 3 boxes waiting at home.

@dawdaw - when you had your alt relocation on your car did you have to modify any wiring to reach the new location?

No Sir! my whole entire harness is completely untouched besides the plug that goes to the alternator is extended, and that's only because I have a madman alternator relocation kit on mine now (runs only alternator)... Are you putting the injectors on your car too?

[JoeliusZ28]

I'm not upgrading injectors until I do the 24x conversion... runs good the way it is now so i have no reason to mess with it!