i dont have access to a tuning suite to disable vats, and only have one key, the connectors for the coils are hooked up
Announcement
Collapse
No announcement yet.
01 A4 SS wont start
Collapse
X
-
aka "Plum Nuts"
- June 4th, 2008
- 5699
- Larry Meissen
- 1998 Trans Am convertible, 2012 Camaro V6 auto IBM
- Macomb, Michigan
- Realtor
- Send PM
when did you do the headers and when did the car not starting problem happen?sigpic
1998 Trans Am Convertible A4 - WS6 hood, WS6 air lid, WS6 rims, drilled/slotted rotors.
Comment
-
the problem started when i got the headers done, initially the car was getting spark, but not getting any fuel, so i replaced the fuel pump/sending unit, it started right up after that, shut it off, and wouldnt fire. found the loose ground, hooked it up, now still not getting spark, i have an extra coolant sensor, i can hook it up, but dont think it has anything to do w the coils.
Comment
-
aka "Plum Nuts"
- June 4th, 2008
- 5699
- Larry Meissen
- 1998 Trans Am convertible, 2012 Camaro V6 auto IBM
- Macomb, Michigan
- Realtor
- Send PM
OK your all over the place, My suggestion, start over forget everything. 1. change the broken sensor. 2. determine if you have fuel. there is a schrader valve off fuel rail. Best is get a gauge and measure pressure should be 45-55 lbs. I put this as #2 because you changed pump, maybe it went bad!. 3. If you have fuel then start and check spark. pull a couple of plugs and check them. by now they could be flooded and if not gapped close or are old may be firing issue. I don't think its the plugs, but you need to eliminate them from being problem. 4. If no spark on any of the coil packs then you have a general problem. 5. get wiring diagram and check each step.Last edited by 98blackbeauty; April 21st, 2009, 10:44 AM.sigpic
1998 Trans Am Convertible A4 - WS6 hood, WS6 air lid, WS6 rims, drilled/slotted rotors.
Comment

Comment