LS6 Intake Swap Question - Quick disconnect fuel line tool use

[V10Venom]

I'm swapping out the intake right now for an LS6 intake and I've got pretty much everything off except for the fuel line right before the fuel rail. I have the 3/8" tool to get it off, and I put it in there and tried pulling it off but it's not working. It's just stuck on. Any tips, advice, etc??

[1BadMoFo]

Go to auto zone or pep boys and get a ruel like removal tool. It is a cheap plastic tool that usually comes in about 6 sizes. It snaps over the fuel like, and then you slide it into the aluminum piece and the line will pull right out.

It costs about 2.99

[1BADAIR]

push the hose in the insert the tool all the way. Then it should pull right out.
The plastic ones don't work well for this. I use the two sided scissor type for the ls1 rails

[OIF1VET]

push the hose in the insert the tool all the way. Then it should pull right out.
The plastic ones don't work well for this. I use the two sided scissor type for the ls1 rails

X2 the scissor type work much better..

[Formula Z]

yep yep

[PewterTA]

Go to auto zone or pep boys and get a ruel like removal tool. It is a cheap plastic tool that usually comes in about 6 sizes. It snaps over the fuel like, and then you slide it into the aluminum piece and the line will pull right out.

It costs about 2.99

thats what I used. Push hard, its a *****

[Virtue]

i used the metal ones on mine, you can rent the kit at murrays, i used the plastic on my buddys and it broke but it still came off

what you doing for the coolant crossover tubes? notching out the underside of the intake?