Best torque arm for the money?

[FASHOOTER]

Did it hook at the stock setting? Depending on how hard the convertor hits you might need to go lower than stock to make it work. It just depends what the car wants.

HHHMMM? No it didn't hook in the stock position, and I noticed no difference going to the highest setting. It does have a set of holes below the stock setting maybe I will start there. That should make it hit tires softer.

[FASHOOTER]

So would a UMI TA and UMI relocation bracket be a good choice?


IT looks like it should clear my duals, they're no where near my trans X member as is

UMI would be an excellent choice, so would BMR. Not a whole lot of difference between the two

[Nocooler]

i know nothing

That makes me know less than nothing.....

[Nocooler]

HHHMMM? No it didn't hook in the stock position, and I noticed no difference going to the highest setting. It does have a set of holes below the stock setting maybe I will start there. That should make it hit tires softer.

It'll hit the tires softer and keep them planted longer.

[Nocooler]

So would a UMI TA and UMI relocation bracket be a good choice?


IT looks like it should clear my duals, they're no where near my trans X member as is

UMI makes good stuff...can't go wrong with it. Someone will probably do a 4th of July sale with 10% off or so - so keep an eye out.

[1BADAIR]

also. how do you do your burnout.?

here is a bad launch lol

[jderry]

I just get them pretty hot, smoking a bit, keep it rolling out the water till it chirps up a and hooks. I'm not in a huge hurry, I want to drive it for a bit before tearing into it again. So I can wait till a 4th sale