1991 Camaro Z28 1LE project

[Lucky SOB]

That SEM trim black is great stuff, used it on the Firebird's engine bay for that classic hotrod black.

[meissen]

continuing to look good!

[JasonH]

POR 15 on the rear axle. Installed brake lines.



It feels good to actually be putting parts back on the car. Installed brake booster, master cylinder, rear brake and fuel lines.



New non-AC heater box. Got rid of that awful aftermarket AC.



Wired the fuel pump with Racetronix hotwire kit.



Installed fuel tank and heat shields.



Installed charcoal canister.



Installed Hawks Third Gen ETC gas pedal bracket.



Installed wiper transmission and cowl



C100 back in

[C2YT]

Looking good!

[WMCCjames]

Was your C100 packed full of brown sticky grease?

[JasonH]

Was your C100 packed full of brown sticky grease?

Yes.

[TylerT/AZ28]

whats the gas pedal bracket?

[JasonH]

whats the gas pedal bracket?

I'm running an LS3 with ETC so that will be for the C6 Corvette ETC gas pedal.

[JasonH]

This is the best third gen lower control arm I've ever seen if I do say so myself. Fresh bushings and ball joint, sandblasted and powdercoated.



Got the big parts back from the powdercoater. I had to send these out because they're too big for our oven. The engine support is beautiful and you can also see the rear sway bar here.



Freshly powdercoated 1LE front sway bar. It looks better than new.

[JasonH]

[DynoDave]

Wow....those DO look nice!

[C2YT]

Looking real good Jason! When do you plan on adding the drivetrain?

[JasonH]

Looking real good Jason! When do you plan on adding the drivetrain?

Soon. I'm waiting on a shipment of LS3 inventory to Katech and then I'll buy one. Also trying to spread my costs out. I've been spending A LOT of money lately.

[C2YT]

Yeah I bet. Powder coating isn't cheap. But I bet its nothing compared to what the LS3 will cost lol.

[Darren]

Yeah I bet. Powder coating isn't cheap. But I bet its nothing compared to what the LS3 will cost lol.

Powder coating is cheap...