jderry's 1996 Camaro

[jderry]

I'm sure it does. I would also like to clean the engine bay up some so it'll help there too.

[Fox Slaughter]

Yeah it does. So far the best thing though its fuel line removal. It looks almost bare on the driverside of my car now.

[jderry]

http://carphotos.cardomain.com/ride_...0011_large.jpg Thinking about this, since it will only be used when I am at the track. I think I will probably do the wire mod soon too. I have a lot of work to do =/ better get to work.

[Fox Slaughter]

I thought about the glove box to. Mine is out right now, but heard problems of overheating.

Track use only might not be a problem though.

[jderry]

I thought about the glove box to. Mine is out right now, but heard problems of overheating.

Track use only might not be a problem though.

That's what I am hoping. I ordered that MSD harness so I don't have to splice any factory wiring.

[Fox Slaughter]

Get some wedge connectors.

I can take a picture of mine.
also I had to cut the mallory harness and extend it just to get it to the passenger side of the car. It will literally only reach the coil to the firewall. The harness is not long at all.
At sometime when I clean everything up I will probably just repin the connector with proper lengths.

[jderry]

I actually have a good selection of wire, got it from a shop that was going out of business, multiple colors and in every gauge 24-6. I will probably add in the exact same amount to each.
I plan on getting some good wire loom to make it as stock looking as possible.

Side note:
Just ordered Brembo rotors, Hawk HPS pads and brake hardware for my LS swap.
Will probably order the SJM kit on Wednesday after I get my paycheck.
I am on spring break next week, so I will have 20+ hours free without class and studying.
Still working 40 hours, but atleast I will have some time to work.

[Fox Slaughter]

Here is a picture of the Mallory harness connected to the MSD harness.

DSCN0179.JPG

Its just some Nylon quick disconnects.

Also don't mine the wire mess. Need to get some looms and make it look a lot better.

[jderry]

Is there a difference in the LS1 calipers casted PBR vs not having it?

[jderry]

It was my understanding that you don't need a sealant for AN style fittings? So what is the red stuff that comes with the Gen X accessories kit? It is in a little tube with a precision applicator. Does not mention it anywhere in the instructions. Also the bottom two sections of my box had nothing in it, am I missing something?

[DETROITMUSCLE]

I was under the same impression, in for answers.

[birdie2000]

I've always heard not to use any sealant on -AN fittings because they seal themselves. If any of the fittings have an NPT fitting on them, those should use sealant. It's probably for any gauges or senders included in the kit.

[DETROITMUSCLE]

aren't they tapered, hence no reason to use sealant.

[Fox Slaughter]

Read same. AN no sealant, NPT sealant.

[jderry]

What plugs should I use? Have TR6 now. Running around 12:1 compression and the 100 shot?