Tweet
Well everyone seems to be giving their project a name. My car is a bit past the project stage so I figured Operation Long haul fit as the goal is to do Hot Rod Power Tour next year.
The upgrades include a new suspension, engine and brakes.
SUSPENSION: Front lowered 1.5" Rear lowered 1"
Eibach progressive rate springs
Edelbrock IAS shocks all the way around
Tie Rods
Ball Joints
Center Link and idler Arm
Control Arm Bushings
G-Braces
Cowl Brace
ENGINE:
388 SBC Stroker with reworked Vortec Heads
Early 70's 4 bolt block bored .060
906 Vortec Heads ported and reworked, good to .550 lift
The following parts are all NEW;
Eagle Stroker Crank
Keith Black Pistons
Hastings Moly Rings
Speed Pro Cam 480/487 and Lifters
Comp Cams Roller Rockers
Comp Cams Push Rods
Melling Select Oil Pump
Edelbrock Double Roller Timing Chain
Champ 7qt Oil Pan with Tray and Scraper
Stewart Water Pump
Fluidampr Harmonic Dampener
Edelbrock Performer Intake
Barry Grant Speed Demon Carb
Holley Fuel Pump
All ARP Fasteners
Motor also came with the Distributor, Starter, Alternator, All Brackets and a GM Serpintine Belt Setup.
Complete motor ready to drop in and play!
Brakes: I have all the parts but will wait until the engine and suspension are sorted out to instal.
drilled and slotted rotors all around
rear disks added
All new brake lines
The upgrades include a new suspension, engine and brakes.
SUSPENSION: Front lowered 1.5" Rear lowered 1"
Eibach progressive rate springs
Edelbrock IAS shocks all the way around
Tie Rods
Ball Joints
Center Link and idler Arm
Control Arm Bushings
G-Braces
Cowl Brace
ENGINE:
388 SBC Stroker with reworked Vortec Heads
Early 70's 4 bolt block bored .060
906 Vortec Heads ported and reworked, good to .550 lift
The following parts are all NEW;
Eagle Stroker Crank
Keith Black Pistons
Hastings Moly Rings
Speed Pro Cam 480/487 and Lifters
Comp Cams Roller Rockers
Comp Cams Push Rods
Melling Select Oil Pump
Edelbrock Double Roller Timing Chain
Champ 7qt Oil Pan with Tray and Scraper
Stewart Water Pump
Fluidampr Harmonic Dampener
Edelbrock Performer Intake
Barry Grant Speed Demon Carb
Holley Fuel Pump
All ARP Fasteners
Motor also came with the Distributor, Starter, Alternator, All Brackets and a GM Serpintine Belt Setup.
Complete motor ready to drop in and play!
Brakes: I have all the parts but will wait until the engine and suspension are sorted out to instal.
drilled and slotted rotors all around
rear disks added
All new brake lines
dyno on another identical engine the same guy built was 375hp at 5600rpm and 444tq at 3400rpm
Comment