Announcement

Collapse
No announcement yet.

Project Panther

Collapse
X
Collapse
Who has read this thread:
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Rolo - there are 2 types of those reduces. Butt fit - like you have posted and slip fit. The slip fit will be expanded and slide over the pipe. Depends on what type of connection you want.

    If it's for the header end of the pipe, you'll want to be able to remove it.
    2000 Formula
    fixed slow junk

    Comment


    • This will just be adapting the pipes into the muffler. Going from 2.5 into 3.

      So then that should work fine for what I need then

      Sent from my C811 4G using Tapatalk

      Comment


      • Have a question about the catch can. I have it installed just like the diagram previous page. I do not know what to do about those hose.

        uploadfromtaptalk1396296959250.jpg

        That is the hose that was attached to the passenger side valve cover ( you can see the rubber cap on the tube bottom right on pic)

        . Am I suppose to take out the entire hose from the driver to passenger and just install one long one in its place going to the PCV valve?

        Hose starts as one from driver then splits into two going to PCV and pass valve cover

        Sent from my C811 4G using Tapatalk

        Comment


        • Just remove that ugly factory hose and run 1 single house from the drive valve cover to the can.


          Comment


          • well I plan on keeping the PCV valve? Ill just run it to the valve and continue on Going to AZ to pick up my hose now


            And found the set of adapter I need for exhaust. So calling insurance tomorrow and hopefully have this dual on next week or the followinf

            Sent from my C811 4G using Tapatalk

            Comment


            • Camaro is insured

              Sent from my C811 4G using Tapatalk

              Comment


              • Finally have everything gathered for the duals. Going to be put on next week


                Looking forward to it
                Last edited by BP_Z28; April 4th, 2014, 01:19 PM.

                Comment


                • What mufflers Rolo?
                  2000 Formula
                  fixed slow junk

                  Comment


                  • Originally posted by BP_Z28 View Post
                    oooooo..I forget who but a member on here painted their dual set black. Want to say its a white fbody.. Bad memory right now.

                    i did it on my old duals.




                    Comment


                    • my old system was painted black as well, never had an issue with the paint.
                      1998 Chevrolet Camaro Z28 - 6 Speed

                      Comment


                      • Just used MCCC, can notice a difference already. Great stuff.

                        Sent from my C811 4G using Tapatalk

                        Comment


                        • Originally posted by BP_Z28 View Post
                          Just used MCCC, can notice a difference already. Great stuff.

                          Sent from my C811 4G using Tapatalk
                          Pics or it didn't happen

                          Comment


                          • Project Panther

                            Off topic..but nice muddy fender Matt lol

                            Dropped the camaro off to Ken this morning. will be driving it home friday

                            Sent from my iPad using Tapatalk
                            Last edited by BP_Z28; April 9th, 2014, 08:20 PM.

                            Comment


                            • Originally posted by BP_Z28 View Post
                              Off topic..but nice muddy fender Matt lol

                              Dropped the camaro off to Ken this morning. will be driving it home friday

                              Sent from my iPad using Tapatalk
                              In matts defense there was no way around it getting muddy. It was winter and he tailored it.

                              Comment


                              • Yea, its all good.. We have all been there

                                Comment

                                Working...
                                X