Tweet
Originally posted by 92conv
View Post
-
he was walking, the kid was using a snowblower.'91 Camaro Modded, LSx, House of Kolor Intense White, lowered, GS chrome 18" wheels, 14" Brembo CTS-V on all 4 corners, LS rear end, FP suspension components
" When in doubt...throttle out ! "
ENVYsion Entertainment Group -
Correct..it was a snowblower that pelted the camaro.
Comment
-
My mistake. I read snow plowed not snow blowed. 
Either way that sucks Rolo.West Michigan Pontiac Club
"A Camaro looks like it can kick your a**, a Trans Am is coming over to do it"Comment
-
Yea, finally have the next couple days off so going to see if I am up to it to clear the path of snow/remove all snow to get a closer look since its drying outComment
-
Met up with Brett, and picked up his catch can! Thanks!Comment
-
Trying to find motivation today to replace starter, and pulleys..but the lazy bug hit me when I woke up.. Little bit going to have a friend help me push the Camaro into garage to get cracking
Sent from my C811 4G using TapatalkComment
-
Putting an underdrive pulley on her Rolo?
Comment
-
Already have one Mike. Have an ASP UP.
Replacing idler pulley and serp
Sent from my C811 4G using TapatalkLast edited by BP_Z28; March 20th, 2014, 01:41 PM.Comment
-
Its snowing by me...Comment
-
Battery, Starter replaced. Finally moved under its own power.
Spent a good 45 min trying to push it into garage. Damn little hills. And slippery Rocky driveway.
Next up pulleys, after I pick Antonio up from school
Sent from my C811 4G using TapatalkLast edited by BP_Z28; March 20th, 2014, 01:38 PM.Comment
-
Well for those that remember this noise.
http://www.mifbody.com/vbulletin/showthread.php?t=49535
I believe we found the culprit.
pulley noise:
Excuse the language at end..I thought I stopped recording
. Started the Camaro up and couldn't hear the tick anymore. Kind if hard to hear it, in the garage so hoping I put a stop to it. Replacing idler pulley next for the hell of it.
Sent from my C811 4G using TapatalkLast edited by BP_Z28; March 20th, 2014, 01:58 PM.Comment
-
And done. Found 1 more bad pulley so need to replace that. Will do that probably during the duals build.
Successful day.
Engage car season opening day.
Sent from my C811 4G using TapatalkComment
-
Vroom... vroom... beep... beepComment
-
At work I'll pick up the other pulley tomorrow. And also some hose for the catch can. I will be using this set up.
I am assuming 3/8th hose is what I want for entire set up? Also. What do I buy to block off the ports on covers?Comment
-
Thats exactly how I had my catch can set up on the pumpkin.
You can pick up a vacuum cap set at autozone to block them off. Just throw a black zip tie around them to keep them in place.
Comment
Comment