1970 Chevelle Restoration

[bri2203]

Its a Miracle! I am going to have to get cut outs eventually. It it OK to be loud and sounds great but slower? Ricers are usually loud and slow....

[Darren]

Wohoo it lives instead of just cranking over! Nice work Brian

[MP81]

It runs! Congrats man!!!

[Lucky SOB]

I'm at work so I can't crank up the volume... but congrats! Hopefully I can make it over in time tonight...

[Darren]

[ITSSLOW]

Is that it running?!!?!? My laptop speakers stopped working. If so,

[Darren]

Is that it running?!!?!? My laptop speakers stopped working. If so,

um it kinda runs, lol wont idle but sure cranks and runs if some dumps gas in it!

[bri2203]

um it kinda runs, lol wont idle but sure cranks and runs if some dumps gas in it!

I just removed the carb so I will have to investigate the problem a little further.

I will have to update this thread with additional pictures!

[Darren]

I just removed the carb so I will have to investigate the problem a little further.

I will have to update this thread with additional pictures!

Sweet keep me posted with the carb issue!

[Darren]

[Darren]

This thread is starting to Fail... I am the only one posting in it. Brian would you like me to start to update it for you? I know work is being done.

[Darren]

This thread is starting to Fail... I am the only one posting in it. Brian would you like me to start to update it for you? I know work is being done.

[bigjon88]

X3

[bri2203]

Sweet keep me posted with the carb issue!

I ended up pulled the whole carb off this time and for the second time I confirmed the fuel pump was working. Then Nick and I useed compressed air and cleaned the accelerator pump, and all of the small holes and found a few missing parts.

I apologise for taking a while to update this thread.
I BIG Thanks to Darren and Fred! Last week we started to install some of the interior panels but I realized I was missing some clips. So we took apart the front bench seat to paint it black. I taped up the wheel well moldings but they I am still undecided on if I like them yet. Then Fred taught Darren how you clean the center of the roof when the car isn't as low as his 3rd gen.

Tonight Fred painted up some 15X7 Rally wheels I installed a few parts on the engine(vacuum fitting for power brakes, choke block off plate.. and then we fought to connect the vacuum line to the trans to the bell housing. It was a frustrating task as the bolt did not want to start in the hole, but thn the end we were successful and I was able to cross off a few things off the list. I am sure I will have some some more progress pictures by the weekend as I am expecting to have more parts on Wednesday.

[Darren]

Updates! No pics of the rallies? I'll stop by sometime this week to check in Looking good Brian are we going to make it?