Announcement

Collapse
No announcement yet.

ok i always heard 100-150 shot is safe but....

Collapse
X
Collapse
Who has read this thread:
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    I would recommend a racetronix kit, it comes with everything you need and also get the wiring harness as well because you'll need better wires to run the higher powered pump.
    Doing less with more


    Comment


    • #17
      ok found it out from an other forum. thanks any ways guys.
      Chris
      00camaro16@att.net

      2000 Camaro SS - ported and polished BBK throttle body, ls6 intake manifold, granatelli mass air flow sensor, Yank 3600 stall torque converter, Texas Speed Torquer 3 cam, hedmann headers and y-pipe, slp intake lid, magna flow cat-back exhaust, ported heads, dyno tuned. 11.53 1/4, ran only once.

      Comment


      • #18
        did you get a racetronix kit? If not your gonna need a casper electronics wiring harness as I mentioned you need thincker gauge wire to run that higher powered pump otherwise it won't run properly.
        Doing less with more


        Comment


        • #19
          A normal pump will require the bucket to be modified(not recommended) Racetonics and fullthrottletech are the only two that have the jet pump nipples for the stock fuel bucket.
          The fuel pumps are not normally the issue with pulling the fuel for a wet kit off the rail. the issue is that the pressure regulator is in the tank and takes forever to compensate and usually causes a lean spike

          Comment


          • #20
            Originally posted by 1BADAIR View Post
            A normal pump will require the bucket to be modified(not recommended) Racetonics and fullthrottletech are the only two that have the jet pump nipples for the stock fuel bucket.
            The fuel pumps are not normally the issue with pulling the fuel for a wet kit off the rail. the issue is that the pressure regulator is in the tank and takes forever to compensate and usually causes a lean spike
            Is there a solution for this?
            Doing less with more


            Comment


            • #21
              Hey Chris,
              If you wouldn't mind - post what you found or post the link. I'm a real advocate for this and hope to get people into the same methodology - if you find the information somewhere else, post what you found in your thread over here because then the next person who tries to find the information here will find what you posted.
              - Brian Meissen
              Owner, MiFBody.com
              Administrator, LTxTech.com


              1994 Camaro LT1 Transplant - 357ci LT1, cammed, stalled, and driven.
              2022 Camaro LT1 - "Cherry Bomb 2"
              Michigan FBody Meet & Greet Car Show 2022
              June 4th, 2022 - 9am to 3pm!!!
              The HUB Stadium, Auburn Hills, MI

              Comment


              • #22
                stenod and harlan used 97 vette rails and v6 return lines. aftermarket rails with a regulator and return.
                to help the lean spike(no fix it) some people run a shorter fuel line than nitrous line after the solenoid so the fuel gets there quicker

                Comment


                • #23
                  Do the LS motors have Forged pistons?
                  Just curious??



                  VicePresident of West Michigan Firebird Club
                  A.K.A The Maverick
                  http://www.cardomain.com/ride/660128/1
                  93 TA Currently Under Construction AGAIN
                  2007 2500 Chevy Silverado Crew Cab w/ 6.0L & 3.73's

                  Comment


                  • #24
                    Originally posted by Phantom383 View Post
                    Do the LS motors have Forged pistons?
                    Just curious??
                    Nope


                    Comment


                    • #25
                      Originally posted by DETROITMUSCLE View Post
                      Is there a solution for this?

                      yes sir. a dry kit, big injectors, and a good tuner

                      I HATE lean spikes, they hurt parts and shock the tires usually causing the car to spin that is traction limited.
                      Last edited by BLKHAWK; February 13th, 2009, 10:25 AM.
                      SB tuning for all your porting and tuning needs.
                      For custom engine builds please call
                      810-689-8286

                      Haters never win and winners never hate

                      Comment


                      • #26
                        in my LT1 i sprayed over a 300 shot in 2 stages into the intake via the intake elbow, no problems and the nitrous was distributed evenly. you dont have to worry about pulling timing on anything under a 125 shot. and you never tune a street cat via the ecu for nitrous, this is just a dumb idea. if you tune it on nitrous your tune wont be right just driving normaly, all you do is retard timing with an ignition box. and for anything under a 200 shot you dont need anything fancy to do it like different fuel rails or any of that jazz, but you should watch fuel pressure while spraying anything big. anything under a 200 shot isnt going to drop fuel pressure low enough to do anything catastrophic.
                        1997 Camaro SS convertible #594-Gone but never forgotten
                        1995 Camaro Z28 hard top - 14:1 355.
                        1997 Camaro SS convertible #455 30th anv #80

                        Comment


                        • #27
                          Originally posted by 1fstss View Post
                          in my LT1 i sprayed over a 300 shot in 2 stages into the intake via the intake elbow, no problems and the nitrous was distributed evenly. you dont have to worry about pulling timing on anything under a 125 shot. and you never tune a street cat via the ecu for nitrous, this is just a dumb idea. if you tune it on nitrous your tune wont be right just driving normaly, all you do is retard timing with an ignition box. and for anything under a 200 shot you dont need anything fancy to do it like different fuel rails or any of that jazz, but you should watch fuel pressure while spraying anything big. anything under a 200 shot isnt going to drop fuel pressure low enough to do anything catastrophic.
                          ls1's are nothing like an lt1.
                          With EFIlive or Hp tuners O.S update the NA is not affected at when tuned for nitrous.
                          Lt'1 have a front mounted regulator. You try that on an Ls1 and you will be buying a new engine

                          Comment


                          • #28
                            ive seen more than a fair share of LS1's spray a 200 shot and be fine, who is the guy from florida with the WS6 that was spraying the bejesus out it for years. and the LS1 intake is 10 times better than the LT1 intake in design.
                            1997 Camaro SS convertible #594-Gone but never forgotten
                            1995 Camaro Z28 hard top - 14:1 355.
                            1997 Camaro SS convertible #455 30th anv #80

                            Comment


                            • #29
                              This coming from the guy who popped several motors on the juice lol


                              No hard feelings Don we know your addicted.
                              Doing less with more


                              Comment


                              • #30
                                Originally posted by 1fstss View Post
                                ive seen more than a fair share of LS1's spray a 200 shot and be fine, who is the guy from florida with the WS6 that was spraying the bejesus out it for years. and the LS1 intake is 10 times better than the LT1 intake in design.
                                I had a 350 hp plate on my LT1 how did you not have distribution problems?
                                and ls1's can use the IAT to pull timing no timing box needed and this will in no way affect the N/A tune-up. Larry's right there are worlds of difference in capabilities of the fuel systems between an LT and LS car
                                SB tuning for all your porting and tuning needs.
                                For custom engine builds please call
                                810-689-8286

                                Haters never win and winners never hate

                                Comment

                                Working...
                                X