can i just put on new wires with no problems?

[motownZ]

well i want some new spark wires and i heard i need to put some thing in the boot. just what is that? and any recommendations? i was thinking some MSD.

and i know 4th gens have a sweet ignition set up stock, but would there be any benifit to add a ignition box. cause my freind put one on his stang. i know we have a coil for each cylinder just asking???

[97rs4life]

wires are a direct swap, some guys add some gel into the boot to get them to slip on easier, but other than that, nothing special needed

[Formula Z]

man, are you a speed typer or or what. some of your spelling takes a minute to absorb.

[motownZ]

naa just a couple couple of cold ones doing the typing. lol

[Formula Z]

lol, ok. ive been there. friends dont let friends drink and type

[kammi10]

there fixed the spelling for you

[GETGONE]

The "gel" isn't for helping it slide on, it's electrical grease to help with conduction and prevent water from getting on the terminals and rusting them. Most good wire sets will come with a small packet of it.

[96mikez28]

there fixed the spelling for you

oh snap, sean of all people fixed your spelling (that's bad)

[motownZ]

The "gel" isn't for helping it slide on, it's electrical grease to help with conduction and prevent water from getting on the terminals and rusting them. Most good wire sets will come with a small packet of it.

do you know if the MSD set comes with the small gel pack???

[motownZ]

and do you just put it on the boots ( the rubber parts) or do you put it all the way down to the metel conductor???

[kammi10]

u don;t really need the gel and yes most the times it does come with it