When I bought this roller it was missing a portion of the harness for the passenger side front ABS harness. Brian (bri2203) sent me a porting from his TA part out (a HUGE thank you!) and I got it soldered/shrink wrapped/twisted. Still ABS INOP light.
Pulled out the scanner. Well, 1998 ABS isn't compatible with my ABS scanner (only 99+ f-body) so I started doing some manual testing.
Checked fuses - all look good (will double check all again this afternoon)
Checked third brake lights - one bulb bad, replaced both.
Checked parking lights - 4 small 194 bulbs bad, replaced.
Checked all three speed sensors - .998 to 1.008 KΩ.
Checked reference voltage at all three - 4.75 volts.
Only ABS INOP light is on, BRAKE light is off.
I have not tried to drive it yet to see if the light will go out. I'm going to unhook the battery for a bit before I try. Any other thoughts/suggestions would be appreciated!
Pulled out the scanner. Well, 1998 ABS isn't compatible with my ABS scanner (only 99+ f-body) so I started doing some manual testing.
Checked fuses - all look good (will double check all again this afternoon)
Checked third brake lights - one bulb bad, replaced both.
Checked parking lights - 4 small 194 bulbs bad, replaced.
Checked all three speed sensors - .998 to 1.008 KΩ.
Checked reference voltage at all three - 4.75 volts.
Only ABS INOP light is on, BRAKE light is off.
I have not tried to drive it yet to see if the light will go out. I'm going to unhook the battery for a bit before I try. Any other thoughts/suggestions would be appreciated!

Comment