best rods for the cost? blown motor? WTF?

[1BADAIR]

The rods normally get numbered so the caps match. Doesn't matter when they go. A machinist will move them around to find the best bearing clearance. The main caps are numbered at the factory.
Our rod caps MUST go back on the same rod cause the are fractured so no two breaks will match

[85z28kid]

I hope everything goes well for you mike with the discussing with Paul.

I know a lot of builders will only stand buy there work if everything is brand new fresh. I would just think that Paul will stand but his work.

Let us know how it goes!

[c0ncEpT]

Billy Briggs Racing engines. Worth the drive.

[WMCCjames]

Give these guys a call, they are in Jenison and do really good work....and more importantly, they stand behind their work...I don't know if they have LS platform experience though....give them a call and ask them.

http://www.pereng.com/

[kammi10]

Give these guys a call, they are in Jenison and do really good work....and more importantly, they stand behind their work...I don't know if they have LS platform experience though....give them a call and ask them.

http://www.pereng.com/

i went and talked to him about building one for me a little while back and he wouldnt touch it.. so im guessing he doesnt have experence with LS engines

[WMCCjames]

i went and talked to him about building one for me a little while back and he wouldnt touch it.. so im guessing he doesnt have experence with LS engines

That's a bummer...I really like those guys...top notch shop!

[Formula Z]

going back to my builder wednesday night. he was kinda speechless after telling him 4 rods were installed backwards. hoping he makes it right

[1BADAIR]

When he asked who said that tell him "larry"
He will know. I'm kinda a big deal

[Formula Z]

lol ill do that

[Darren]

When he asked who said that tell him "larry"
He will know. I'm kinda a big deal

your not known by "nancy" there?

Sounds like he might work with you, thats good news.

[meissen]

When he asked who said that tell him "larry"
He will know. I'm kinda a big deal

[TORN]

I see his first name is Paul, can I ask what the builders full name is?

[85z28kid]

Ahhh I'm drawing a blank that's for sure. I can't think of it ATM. But the shop is accu-pro racing engines.

[Formula Z]

paul elsworth. hes a good guy and a smart guy, just thinking he doesnt know LS

[98blackbeauty]

take the pictures that Larry sent you with you when you take in the engine.