Project:VRE 383 Turbo Firehawk

[VictoryRacingEngines]

Engine
Displacement: 383 ci
Heads: Stock LT1 Castings, ported by ET Performance
Fuel Injectors: 60# Mototrons
Compression Ratio: 9.0:1
Camshaft: Custom Victory Racing Engines Turbo Camshaft
Throttle Body: Holley 58mm
Intake Manifold: Stock Lt1
Exhaust: VRE Headers, 3" pipe all the way back to 3" Flowmaster Muffler

Fuel System
2-255lph Pumps
Aeromotive Pressure Regulator

Transmission
Transmission: Stock T56 Six Speed
Clutch: Mcleod Street Twin

Rear End
Moser 12 Bolt 4.10 Gears

Turbo Kit Specifics
Turbo: Turbonetics 76mm Turbo
Intercooler: 3" Air to Air Intercooler
Hotside: Victory Racing Engines Custom Headers
Water/Meth: AEM
Boost Controller: Turbonetics Dual Boost Controller
Wastegate: JGS
Blow Off Valve: JGS 44mm

[my95z28]

so what does it run?

[CHMLEON]

Lookin good.

[PACE]

looks good guys

[81DaytonaPaceCar]

Wow.

Great setup...what kind of boost are you looking to make and what kind of horsepower?

[Phantom409]

You have to be running a dished piston like -18cc's right?

I love the setup
What does it cost for the turbo setup?

[SoulTerror]

Sweet!

[VictoryRacingEngines]

The customer has been driving it for about a week and is just put some "break in" mile on it. We are swapping the gears sometime next week, and going to the dyno. After that we hope to be able to hit a Wed or Sat T-N-T at Milan.

so what does it run?

[VictoryRacingEngines]

We are using a dual stage boost controll, and it is set to 10 for stage 1 and 18 for stage 2. We are not expectiong crazy numbers, but I think we can it the 600+ area pretty easily on pump gas.

Wow.

Great setup...what kind of boost are you looking to make and what kind of horsepower?

[VictoryRacingEngines]

We are running a Diamond dished piston, but off my head I don't remember the actually dish of the piston.

We are actually going over the cost to recreate this kit for a few members of another website. All I can say for now is it is less then the cost of the other current alternatives.

You have to be running a dished piston like -18cc's right?

I love the setup
What does it cost for the turbo setup?

[BTplaya]

Looks great man. Nice clean install. Turbos are always the most fun to drive.

[meissen]

Very cool!

[Phantom409]

So would it cost more to have this pipe made straight so it don't get in the way of the valve cover?


I'm missing a lot of that stuff

[VictoryRacingEngines]

In this application it would have been very a very tight fit to go start from the collector. It really itsn't too bad taking off the valve cover on the drivers side.

So would it cost more to have this pipe made straight so it don't get in the way of the valve cover?


I'm missing a lot of that stuff

[ramairusty]

All I can say is WOW, looks great.