Looking for new engine, trans, rear end....

[kammi10]

aint no way that a runnin 800 horse 383 is 300 bucks. and i doubt its 800 horse anyway unless its got some sort of forced induction or nitrous

[1bad83ta]

lol ya getting 800hp outta a 383 is a MAJOR task.

[81DaytonaPaceCar]

lol ya getting 800hp outta a 383 is a MAJOR task.

Yep.

CAN be done. Not sure how streetable it would be. Or how long it would last...

[Lousiffer]

well supossedly its out of a wrecked camaro, its already built and the guy iim buying it off of does that for a living.. buys scrap cars and sells parts. and he only does it to pay bills... lol so if not ohg well but hey if i can get that for less than a grand F***IN WOOT!!!!!

[Phantom409]

Did you find a motor??

Don't know if a LT-1 sounds good or not but I have a 355 I'm building to sell.
It will be fully studed, Comp Roller Tip Rockers 1.52 ratio, Guid Plates, Comp 306 cam, Ported stock heads, Intake, Fuel Rails, SVO 24lb Injectors.

[Orange Terror]

Holy crap this is an old thread!!!

[Lousiffer]

Did you find a motor??

Don't know if a LT-1 sounds good or not but I have a 355 I'm building to sell.
It will be fully studed, Comp Roller Tip Rockers 1.52 ratio, Guid Plates, Comp 306 cam, Ported stock heads, Intake, Fuel Rails, SVO 24lb Injectors.

ok no i havent found a motor yet, how much and for the time being will this motor bolt into my stock trans and rear end?

[MyBadZ28]

yea it is a ZF 6 speed i still have it and have no need for it. Make an offer i am looking to get rid of it. So let me know

That's a ZF isn't it? How much you want for it?

[Lousiffer]

ok.. im confused.. what is this zf motor? i though we were talking about an lt1 but tell me about this ZF

[MyBadZ28]

haha sorry for the confusion. It is a ZF 6 speed transmission

[Lousiffer]

so its the motor and trans? do you have the ability to do the changeover from auto? if i bough the parts and hopw much would you want for everything and would you do the install?

[93formulalt1]

The ZF is simply a 6 speed manual transmission used in the Corvettes in the late 80's-early 90's. It is not an engine, and I doubt Dan has the engine to go along with it. These are strong transmissions stock, so you should have no problems throwing some big #'s at it without it breaking.

[Lousiffer]

ok dan, would you have the ability to install it as of now? im in a 4 spd auto right now n a 305, i might as well do this in stages, but i have to keep the car, running, as it is my daily driver

[kammi10]

yeah u better buy a daily driver if u wanna do an engine swap then

[MyBadZ28]

Yea unfortunately the engine is in my 84 Z so i don't have that ready acceptable. as for installing it. You would have to get all the parts needed (pedals, Slave cylinder, cross member, and others i haven't put a 6 speed in a 3rd gen yet i was going to thats why i got the trans but never ended up doing it. I would think if you got all the parts it could be put in in a weekend. Where are you located?