Tweet
Well, I've decided that I want to do the T56 swap so badly now that I'm willing to take my car out of commission for a while to do it.
I am looking for all of the parts I would need to do the swap. These include:
T56 transmission, bellhousing, slave cylinder extension piece, clutch fork, fork t-stud, inspection cover, shifter, flywheel, pressure plate w/throwout bearing, clutch disk, clutch alignment tool.
master cylinder with U-bolt, slave cylinder, reservoir
new roller pilot bearing
T56 tranny crossmember, tranny mount (can use A4 tranny mount - recommend LS1/1LE tranny mount)
exhaust mount, torque arm bracket, torque arm bushing (can use A4 TA bushing)
pedal assembly with all the switches and clip for clutch pedal
shifter console insert (replaces automatic shifter insert)
lower shift boot
bolts - bellhousing to tranny, flywheel, pressure plate to flywheel, slave cylinder nuts, master cylinder U-bolt nuts, inspection cover screws, lower shift boot screws. CAGs pigtail (not necessary), VSS pigtail (12101899), reverse lockout pigtail (12101857), reverse light pigtail (12085485). The pigtails are expensive, but necessary. Connectors for the pedals are not necessary.
I am willing to trade my 700R4 trans and cash on my end for the kit. I don't know how much cash this is going to cost me, but I love my car, I've seen the write-ups on doing the swap, and I want to do it.
Please send me a PM if you have any ideas, I would like to get started on this within the next couple of months.
I am looking for all of the parts I would need to do the swap. These include:
T56 transmission, bellhousing, slave cylinder extension piece, clutch fork, fork t-stud, inspection cover, shifter, flywheel, pressure plate w/throwout bearing, clutch disk, clutch alignment tool.
master cylinder with U-bolt, slave cylinder, reservoir
new roller pilot bearing
T56 tranny crossmember, tranny mount (can use A4 tranny mount - recommend LS1/1LE tranny mount)
exhaust mount, torque arm bracket, torque arm bushing (can use A4 TA bushing)
pedal assembly with all the switches and clip for clutch pedal
shifter console insert (replaces automatic shifter insert)
lower shift boot
bolts - bellhousing to tranny, flywheel, pressure plate to flywheel, slave cylinder nuts, master cylinder U-bolt nuts, inspection cover screws, lower shift boot screws. CAGs pigtail (not necessary), VSS pigtail (12101899), reverse lockout pigtail (12101857), reverse light pigtail (12085485). The pigtails are expensive, but necessary. Connectors for the pedals are not necessary.
I am willing to trade my 700R4 trans and cash on my end for the kit. I don't know how much cash this is going to cost me, but I love my car, I've seen the write-ups on doing the swap, and I want to do it.
Please send me a PM if you have any ideas, I would like to get started on this within the next couple of months.
Comment