350 Heads wanted

[DMX69785]

Need some 350 heads, doesn't matter what they're off of. bare or assembled. lmk what you have.

[JoeliusZ28]

well hello Joel,

I have some LT1 heads I am willing to sell, but im guessing thats not what youre looking for - theyre reverse cooled.

[wezeles]

ive got some nice pre 87 SBC camle hump heads at my machine shop screw in studs and isky tripple springs good for up to 700 lift... dont need them anymore great stock heads 350hp+ you can have them for whatever they charge me for machining... i think its between 100-150

they are drilled for accesories might need new valves thats it... i have the stock 1.94 1.5 valves but was going to replace them with a new set...

here is the mortec on the casting number

3973370....69-70...350..........over the counter in US, Canadian 350/300hp production use in Pontiac, 64cc, straight or angle plug

its basically a ported and polished camel hump "has the camle hump casting" but with smaller valves which is fine for a smaller cubic inch motor... just wont work well on my 383... guy at the machine shop wants them gone... took him over 3 months to just do screw in studs and cut for the new springs... he told me 2 weeks had a motor to build and didnt wait on him so got new heads since then... they are just sitting there not sure if he did anything else to them yet... but i know he still has them he just called me today. half way done just needs valves

[Jeffzilla]

I have a set of 883's................

[MrMojoRisin681]

I have my stock 1978 heads. I have everything for them. They're smogger heads. 72cc I believe since they made low compression on my engine.

[shawnc16]

I have a set of Canfield aluminum heads for sale.. I need to get rid of em asap!

[csmith4153]

I have a set of mid 70's 350 heads in the barn. All the valves are out and in a box, half of the press in studs have been removed to make room for screw in studs. They have been sitting around for about 15 years or so.
What ever you think they are worth.