Tweet
Hi guys, I'm continuing to sell off stuff out of the garage so here is a full listing of some remainders:
All pics here: http://imgur.com/a/0FJl8
1) 3917291 casting SBC heads, 65cc camel hump. Removed from our '67 camaro before we rebuilt with different heads. Have dual valvesprings and are good to go after a thorough cleaning. $300 or best.
2)1st gen chrome, mostly in shit condition. Have beauty rings for 15" wheels, and a lot of windshield/cowl pieces. $20 or best.
3) 1st gen front valence. Surface rust but not rusted though. Restorable. $20 or best.
4) 1st gen cowl. Again, surface rust but not rusted through and as far as I know also dent-free. $20 or best.
5) 1st gen center console. Not in great condition (see pics). Has a cut in the pass side but other than that it's "ok" $20 or best.
6) Complete 1st gen HVAC unit with heater core and blower motor. Still has control cables attached...at least I think it's complete. $30 or best.
7) 1st gen front corner piece (goes below the front fender...I think). $5 or best. Not rusted through!
8) 1st gen RS grille center. Couple of pieces of the grid are broken off, could be repaired if you put your heart into it. $5 or best.
9) Holley 750 double pumper carb (#4779). Complete and clean but needs to be fully rebuilt (new seals/power valve needed). Floats and linkage are intact. $200 or best.
10) 4th gen pacesetter 3" Y-pipe with E-cutout. Y-pipe is in ok condition, has some really ugly welds on it. Cutout is fcked at the moment, motor is ok but plate will need to be JB-welded back into place, drilled/bolted, or welded, you choose. Will also need to be re-wired because I don't have the connector. $50 or best for both.
11) 4th gen 3" Hooker aerochamber cat-back, in good condition. Over-the-axle pipe was cut, but *could* be welded back together because I still have it. No pics yet but will post later. Chrome quad tips as seen in this pic: http://imgur.com/hvDHmxO $75 or best.
12) 4th gen Stock 16" firebird wheels, with tires. Fronts are sumitomo, rears are BFG's. Will get pics up when I get a chance. $150 or best.
13) 4th gen stock panhard rods (2 of them): $1 or best offer.
14) 4th gen lower control arms: $1 or best offer.
Also have stock LS1 cam, 4th gen A/C pump and condenser.
Prices negotiable.
All pics here: http://imgur.com/a/0FJl8
1) 3917291 casting SBC heads, 65cc camel hump. Removed from our '67 camaro before we rebuilt with different heads. Have dual valvesprings and are good to go after a thorough cleaning. $300 or best.
2)1st gen chrome, mostly in shit condition. Have beauty rings for 15" wheels, and a lot of windshield/cowl pieces. $20 or best.
3) 1st gen front valence. Surface rust but not rusted though. Restorable. $20 or best.
4) 1st gen cowl. Again, surface rust but not rusted through and as far as I know also dent-free. $20 or best.
5) 1st gen center console. Not in great condition (see pics). Has a cut in the pass side but other than that it's "ok" $20 or best.
6) Complete 1st gen HVAC unit with heater core and blower motor. Still has control cables attached...at least I think it's complete. $30 or best.
7) 1st gen front corner piece (goes below the front fender...I think). $5 or best. Not rusted through!
8) 1st gen RS grille center. Couple of pieces of the grid are broken off, could be repaired if you put your heart into it. $5 or best.
9) Holley 750 double pumper carb (#4779). Complete and clean but needs to be fully rebuilt (new seals/power valve needed). Floats and linkage are intact. $200 or best.
10) 4th gen pacesetter 3" Y-pipe with E-cutout. Y-pipe is in ok condition, has some really ugly welds on it. Cutout is fcked at the moment, motor is ok but plate will need to be JB-welded back into place, drilled/bolted, or welded, you choose. Will also need to be re-wired because I don't have the connector. $50 or best for both.
11) 4th gen 3" Hooker aerochamber cat-back, in good condition. Over-the-axle pipe was cut, but *could* be welded back together because I still have it. No pics yet but will post later. Chrome quad tips as seen in this pic: http://imgur.com/hvDHmxO $75 or best.
12) 4th gen Stock 16" firebird wheels, with tires. Fronts are sumitomo, rears are BFG's. Will get pics up when I get a chance. $150 or best.
13) 4th gen stock panhard rods (2 of them): $1 or best offer.
14) 4th gen lower control arms: $1 or best offer.
Also have stock LS1 cam, 4th gen A/C pump and condenser.
Prices negotiable.
where you at these days?
[MENTION=2226]Fbomb[/MENTION]
Comment