Tweet
I have a 4 bolt main one piece rear main seal roller cam ready engine with less than an hour of run time.
-Speed Pro Hypereutectic 4 valve relief flat tops with sealed power moly rings
-Comp Cams 270H flat tappet cam. Specs are .470/.470 lift and 224/224 duration
-Sealed Power rod and main bearings with dura bond cam bearings
-Stock crank with GM X rods with new gm rod bolts
-Felpro gasket set
-Comp Cams hardened push rods
-Comp Cams adjustable timing set
-Canton timing cover with arp timing cover stud kit
-Canton 6 qt oil pan
-New water pump
-Summit racing 8" balancer
-Melling m55hv oil pump with an arp oil pump driveshaft
All machine work was done by Performance Automotive in Hillsdale Michigan.
Heads are stock 624 castings with 1.94 intake valves. They are new off of a crate engine I had. I am only selling this engine because I have medical bills. I installed the engine into my truck, broke in the cam and drove it for about 20min to seat the rings. Then I had an emergency room visit that was as you all know extremely costly so I need to pay the med bills. Contact me through email cjoform@gmail.com or you can call and leave a message with phone number 517-462-81sixone I work 11-7 through the day so you may have to wait a bit before I call you back but you will get a call. Price is 1000 or best offer. I am not interested in trades. Cash only and cash talks. This is located in Hillsdale county. I do not have a truck to load it in so if youre interested the logistics are all on you.
-Speed Pro Hypereutectic 4 valve relief flat tops with sealed power moly rings
-Comp Cams 270H flat tappet cam. Specs are .470/.470 lift and 224/224 duration
-Sealed Power rod and main bearings with dura bond cam bearings
-Stock crank with GM X rods with new gm rod bolts
-Felpro gasket set
-Comp Cams hardened push rods
-Comp Cams adjustable timing set
-Canton timing cover with arp timing cover stud kit
-Canton 6 qt oil pan
-New water pump
-Summit racing 8" balancer
-Melling m55hv oil pump with an arp oil pump driveshaft
All machine work was done by Performance Automotive in Hillsdale Michigan.
Heads are stock 624 castings with 1.94 intake valves. They are new off of a crate engine I had. I am only selling this engine because I have medical bills. I installed the engine into my truck, broke in the cam and drove it for about 20min to seat the rings. Then I had an emergency room visit that was as you all know extremely costly so I need to pay the med bills. Contact me through email cjoform@gmail.com or you can call and leave a message with phone number 517-462-81sixone I work 11-7 through the day so you may have to wait a bit before I call you back but you will get a call. Price is 1000 or best offer. I am not interested in trades. Cash only and cash talks. This is located in Hillsdale county. I do not have a truck to load it in so if youre interested the logistics are all on you.
Comment