RAM Aluminum 2 pc. Main Flywheel with PowerGrip Clutch

[69LS1]

I'm Selling a RAM 2555 Billet Aluminum Flywheel that is used to mount a LT1 t56 to a early 2 piece rear main Small Block Chevy. Used for less than a 1000 miles. Still has CNC marks on Flywheel. Comes with Flywheel, Pressure Plate, and Clutch Pad. Has throwout bearing installed. Paid over $800 for everything. Want to get $600 for it all. Thought I'd post it here first. Let me know if you are interested or have questions. Thanks!

[85z28kid]

Did you get your ls1 and t56 out of that wrecked Camaro off of craigslist? I was so Gunna buy it but I decided to go big block instead. What did you get the car for?

Back on topic what's the horsepower and foot pounds rating on the clutch setup? I'm Gunna be making around 550 and 575 out of my big block so it needs a good clutch!!

[69LS1]

Did you get your ls1 and t56 out of that wrecked Camaro off of craigslist? I was so Gunna buy it but I decided to go big block instead. What did you get the car for?

Back on topic what's the horsepower and foot pounds rating on the clutch setup? I'm Gunna be making around 550 and 575 out of my big block so it needs a good clutch!!

Yeah i got it off CL a few months ago. Got it to my driveway for just under $1200 total. not a bad deal so far. hoping the internals are still okay. no cracks so far. lol. I was going to go with sbc/lt1 t56 combo in the car, but then this deal came along.

But as for the clutch, I will look up the specs for you when I get home. I'll post them tonight. Sorry about that. should of been prepared.

[85z28kid]

Yea that was cheap for the whole car. I should of bought it and parted it but was to lazy lol. Big block deff the way to go anyway lol.

[69LS1]

Yea that was cheap for the whole car. I should of bought it and parted it but was to lazy lol. Big block deff the way to go anyway lol.

yeah big block would be sweet. But don't you have to mod the firewall? Also, I sent you a PM, did you get it?

[85z28kid]

Yea 550 ftlbs is gunna be fun!

Nope not all it's a tighter fit especially with heat in the car. And running 2 1/4" primaries. Yea I got your pm I just gotta see what I can cone up with cuz I already got a flywheel cuz my motor is externally balanced. Would you be interested in splitting up the clutch and flywheel?

Also post that flywheel on thirdgen.org and will sell fast!! Or I'll post it for you if you give me a price you would like for it. Pm with your decision if you want to split it up.

[69LS1]

Wow that would be a tight fit for all that. But as for splitting them up I am going to hold off. Thanks for the interest though. and thanks for the offer to post it on thirdgen. I will contact you again if i decide to take you up on the offer.