4th Gen rear axles 2:73 stock and 4:10

[Joedashredder93]

I'll talk it over with the old man. thanks

[craig62989]

Yes, but they would have to be set-up.

what do you mean set up ?

[sman]

No I dont believe they will fit, 3.23 is a 3 series carrier, and 3.08 and below is a 2 series. So you could put your gears in but youd have to use your center section(carrier), therefore loosing the posi.

By set up he means that the gears need to be properly shimmed and check the wear patteren, to my knowledge its not good practice to use a used set of gears in another axle because its almost impossible to get them to wear the exact same as they did in the last axle. IIRC.

[Joedashredder93]

would this be the same for me?

[craig62989]

thanks spencer im going to see what i can do to come up wit some money to buy the 273 one to put in my v6 , can i put my drums on it ?

[bud_light_zero2000]

thats what I need

[Razmiblackz28]

Correct. My reply was based on moving the gear set and carrier over to this housing. To use the 2 series limited slip you would need a ring gear spacer and I'd suggest finding a 3 series carrier instead.

Your gears and diff will fit this housing but will need an install kit.

No I dont believe they will fit, 3.23 is a 3 series carrier, and 3.08 and below is a 2 series. So you could put your gears in but youd have to use your center section(carrier), therefore loosing the posi.

By set up he means that the gears need to be properly shimmed and check the wear patteren, to my knowledge its not good practice to use a used set of gears in another axle because its almost impossible to get them to wear the exact same as they did in the last axle. IIRC.