Lt1 engine

[my1994z28]

This is complete plug and go setup..engine .020 over speed pro pistons and rings,scat rods,heads have been ported(no flow #s)2.02 1.55 valves,5 angle valve job,intake gasket matched,gm opti with msd cap and rotor,gm performance water pump,march under drive pulleys,msd 8.5 wires,comp 306 cam,comp 1.6 rrs,comp push rods,new starter,6 spd trans with 27,000 miles,spec 3 clutch...car was dynoed tuned @Vector motorsports in clinton twp..sheet available..there is more i am forgetting...you can hear run before i pull it out...serious buyers only.. 4,800.00 OBO

[Kwazrollinz28]

sounds like a true badass, I have about that and my motor rips hard.

[Phantom409]

[meissen]

Mike? Didn't you JUST install this motor a few months ago? What the heck happened, dude? And ya mention it was dynotuned by Steve, what numbers did it put out?

[my1994z28]

It was dynoed by Kurt @ Vector Motorsports,361 rwhp and 345tq..I think that there is a little more in it....two words as to what happened.Michigan economy..

[meissen]

Sorry to hear, Mike.

[my1994z28]

Thanks,I may sell the whole car for $9000.00,94 z28 1le,edelbrock adjustable torque arm,and panard bar,new struts,shocks,and rear springs,safety loop,lakewood lcas,msd ignition,slp line lock,weld pro stars,hurst shifter.trick flow diff cover,drag bags in rear,brand new flowmaster cat back,new brakes,slp fan switch,autometer tach w/shift light...car ran 12.83@110mph, a few weeks ago,with a set of 4.11 gears its capable of running low 12s or high 11s..please serious buyers only...thanks mike

[bigjon88]

bump for ya man good luck with sell

[my1994z28]

Thanks again,i have pics for whoever is interested..

[my1994z28]

Bump for the holiday weekend!!!HAPPY 4TH OF JULY