Tweet
I made a post on criagslist and now i figure i would post it for sale on here.
$2,000 firm.
this is the motor i built for my 84 and ended up selling the body .. and now i have nothing to do with it and i want to pay some things off and finish the t/a
heres my CL post.
.
.
.
Very nice engine all assembled by Allard Engineering out in davison michigan.
There is way more into the motor than what im asking but times are getting really tough and i need the motor gone to finish another project.
2 bolt main chevy 350
.040 over / hot tanked / decked
Hard Blocked
GM Vortec fully machined cylinder heads with manley stainless steel race valves, gm performance 1.6 roller rockers, comp cams magnesium retainers & valve locks, bronze valve guides.
JE 10.5:1 pistons
Edelbrock performer plus rpm cam & lifter set.
http://store.summitracing.com/partde...ew=1&N=700+150+
Melling pushrods & high volume oil pump
Full clevite engine bearing set.
Edelbrock double roller timing chain
Weiand Stealth intake manifold
a brand new edelbrock 650 endurashine manual choke carb comes with it.
I have a B&M torque master 2500 stall torque converter for a th-350/400 trans i will throw in too ( never been used & full of B&M trick shift fluid )
This is a very nice engine that HAS NEVER BEEN RUN!
i have no use for this engine since i sold the body it was intended for.
I have lots of pictures of the build process and internal parts.
so if you are interested there are more pictures on demand.
$2,000 firm.
this is the motor i built for my 84 and ended up selling the body .. and now i have nothing to do with it and i want to pay some things off and finish the t/a
heres my CL post.
.
.
.
Very nice engine all assembled by Allard Engineering out in davison michigan.
There is way more into the motor than what im asking but times are getting really tough and i need the motor gone to finish another project.
2 bolt main chevy 350
.040 over / hot tanked / decked
Hard Blocked
GM Vortec fully machined cylinder heads with manley stainless steel race valves, gm performance 1.6 roller rockers, comp cams magnesium retainers & valve locks, bronze valve guides.
JE 10.5:1 pistons
Edelbrock performer plus rpm cam & lifter set.
http://store.summitracing.com/partde...ew=1&N=700+150+
Melling pushrods & high volume oil pump
Full clevite engine bearing set.
Edelbrock double roller timing chain
Weiand Stealth intake manifold
a brand new edelbrock 650 endurashine manual choke carb comes with it.
I have a B&M torque master 2500 stall torque converter for a th-350/400 trans i will throw in too ( never been used & full of B&M trick shift fluid )
This is a very nice engine that HAS NEVER BEEN RUN!
i have no use for this engine since i sold the body it was intended for.
I have lots of pictures of the build process and internal parts.
so if you are interested there are more pictures on demand.
Comment