F/S Swap Meet left overs

[86iroc305]

so have some goodies left over from a swap meet i set up at this past weekend

sbc roller tip rockers 3/8 stud non self align $50


complete ls1 rear brakes with zinc coated slotted rotors $150 (SOLD)


c4 corvette front calipers $75


ls1 rear calipers $50


3in flowmaster exhaust $100


2.5in flowmaster exhaust $75

[Phantom409]

with the sale

[MP81]

Good luck with the sale!

[my95z28]

Are the Ls1 rears any bigger than LT1 rears?

[JoeliusZ28]

Are the Ls1 rears any bigger than LT1 rears?

i think like a half inch, but yes.

[meissen]

Yeah I could've sworn LT1 rims don't fit on the back of LS1's because the calipers are bigger.

[86iroc305]

ls1's need 16's to clear some people have gotton 15's to clear with minimal grinding, i have ls1 on the back off my car and run 16in iroc with et streets. the rotor on lt1 is a 11.5 i think and 12in on ls1 (the rotor is also thicker)

[JoeliusZ28]

Yeah I could've sworn LT1 rims don't fit on the back of LS1's because the calipers are bigger.

that is the hub you are thinking of. pretty sure the brakes wouldnt affect that - they just came in parallel from the factory.

[meissen]

Ah OK, that's probably what it was then. I knew it didn't fit over something

[my95z28]

that is the hub you are thinking of. pretty sure the brakes wouldnt affect that - they just came in parallel from the factory.

Werd, I had to do some dremmeling on the steelies I got for winter cause they wouldn't fit over the rear hub. Fronts were fine though.

[steddy]

Are those an old set of yellow tuff wheels (yellow) in the background?