Tweet
Finally all done using our 4th Gen mock-up car. It served an excellent job for us in the creation of many turbo kits and most of our standard kits we sell.
1998 Camaro, originally a V6 vehicle.
Background info: Purchased from a member upon here many years back. He had this car set-up running a 6.0l, 4l80-e and 9". The cluster was updated to that from a V8 car, fuel tank replaced for a 99+ Plastic tank with a racetronix kit I believe installed in the tank. Car was a running and driving V8 car with the newer fuel tank, V8 wiring, cluster, etc when it was parted out and I purchased the roller. It is a hard-top, crank windows car, excellent to use for a drag set-up. The tunnel has already been clearance'd of course for the 4l80-e that was previous ran.
Car has no engine, no transmission, no seats, and the rear end that is in the car now is junk, but works to roll the car.
Car has an older PA K-member in the car that doesn't fit well with the factory lower a-arms so the a-arms are not bolted in. I have a stock K-member here as well that goes with the car.
Engine bay was re-done as seen in the photos with a black POR product.
The car has not been hacked up, both radiator supports still in place as shown.
I may be missing some things so don't hold me to it, but I believe the car is a engine/trans/rear/engine wiring harness/radiator/fans/seats away from being completed. I stole the hood latch off it as well for another car. I had this car at one point 95% complete however sold the old mock-up car and re-disassmbled this to make as our mock up vehicle.
Front bumper support and foam included as shown on inside of car. Front bumper is rough, but included.
Mock up engine that you see in photos will be removed.
SOLD!
Any questions feel free to ask or post up!
1998 Camaro, originally a V6 vehicle.
Background info: Purchased from a member upon here many years back. He had this car set-up running a 6.0l, 4l80-e and 9". The cluster was updated to that from a V8 car, fuel tank replaced for a 99+ Plastic tank with a racetronix kit I believe installed in the tank. Car was a running and driving V8 car with the newer fuel tank, V8 wiring, cluster, etc when it was parted out and I purchased the roller. It is a hard-top, crank windows car, excellent to use for a drag set-up. The tunnel has already been clearance'd of course for the 4l80-e that was previous ran.
Car has no engine, no transmission, no seats, and the rear end that is in the car now is junk, but works to roll the car.
Car has an older PA K-member in the car that doesn't fit well with the factory lower a-arms so the a-arms are not bolted in. I have a stock K-member here as well that goes with the car.
Engine bay was re-done as seen in the photos with a black POR product.
The car has not been hacked up, both radiator supports still in place as shown.
I may be missing some things so don't hold me to it, but I believe the car is a engine/trans/rear/engine wiring harness/radiator/fans/seats away from being completed. I stole the hood latch off it as well for another car. I had this car at one point 95% complete however sold the old mock-up car and re-disassmbled this to make as our mock up vehicle.
Front bumper support and foam included as shown on inside of car. Front bumper is rough, but included.
Mock up engine that you see in photos will be removed.
SOLD!
Any questions feel free to ask or post up!
Comment