Tweet
Putting my Camaro back up again, this time i'm serious about selling. I haven't touched the car in over 2 months.
97' camaro Z28 cloned to a SS. It is stored in the winter, and is barely driven. It has a 6 speed manual trans and is a hardtop. It has 94,xxx miles and is only driven about once or twice a month. The underbody is clean along with the whole car. It has 35th anniversary floor mats and the 35th logo on the seats. This car has seen the track three times since I have owned it, once before the cam swap and twice after. It has ran the best of 12.78 @ 113.5mph with a 2.15 60ft, car was on street tires every visit to the track so dont be fooled by the slow times, this car has 11 sec passes with a sticky tire. I also have a folder full of receipts from me and previous owners.
Will take $6000 from any MIfbody memeber!!!!!!!!!
I am asking $7500 and am pretty firm on that price, But if you have a solid offer I will work with you!! My number is (989)330-4098, Text works best for me if not call, PM, or email. If you want to trade straight up or even partial trade send me an offer and I will consider it!
1997 Camaro Z28/SS Clone
94,xxx miles
Clear Title In hand
Hardtop
Dark charcoal leather
6 speed
Interior 9/10
Exterior 8.5/10
LT1 SS fiberglass hood
LT1 SS spoiler
Camaro SS dash plaque
GM SS badges
Cannot tell it's a Z28 unless you look at the RPO codes
Stock bottom end LT1 5.7ltr
Ported, Polished, and Milled stock casting heads by AES in Chicago
Comp Magnum 1.6RR's
Comp 918 springs
Trickflow chromoly hardened pushrods
LS7 lifters
Crane 234/242 .574/.595 112 lsa w/1.6 rocker
Cam installed spring 2011
Ported and Polished Intake manifold
Ported and Polished throttle body
Port work done by AES in Chicago
Kooks 1 ¾ Long Tube headers
Kooks catless Y pipe
Borla XR1 dumped before axle
MSD ign module
NGK plus
SLP Blackwing CAI
Tuned by Madtuner/madz28
LT4 knock module
HID low beams
Summit Racing Shift light, installed in the driver side vent.
Stock T-56
Competition Clutch stg 2 (installed summer 2011)
Resurfaced flywheel
new Pilot Bushing
Pro 5.0 power tower shifter
UMI Pistol Grip
Poly Motor Mounts
BMR boxed subframe connectors
UMI lower control arms
UMI strut brace
SLP Drive shaft loop
Stock 10 bolt rear
Richmond 4.10's
OEwheels ZR1 Deep Dish replicas 17x9.5, 17x11 (fall 2010)
Nitto 555's 275,315's (90% tread)
LS1 front brake swap
***driverside mat is wet from my shoes, not stained.****
97' camaro Z28 cloned to a SS. It is stored in the winter, and is barely driven. It has a 6 speed manual trans and is a hardtop. It has 94,xxx miles and is only driven about once or twice a month. The underbody is clean along with the whole car. It has 35th anniversary floor mats and the 35th logo on the seats. This car has seen the track three times since I have owned it, once before the cam swap and twice after. It has ran the best of 12.78 @ 113.5mph with a 2.15 60ft, car was on street tires every visit to the track so dont be fooled by the slow times, this car has 11 sec passes with a sticky tire. I also have a folder full of receipts from me and previous owners.
Will take $6000 from any MIfbody memeber!!!!!!!!!
I am asking $7500 and am pretty firm on that price, But if you have a solid offer I will work with you!! My number is (989)330-4098, Text works best for me if not call, PM, or email. If you want to trade straight up or even partial trade send me an offer and I will consider it!
1997 Camaro Z28/SS Clone
94,xxx miles
Clear Title In hand
Hardtop
Dark charcoal leather
6 speed
Interior 9/10
Exterior 8.5/10
LT1 SS fiberglass hood
LT1 SS spoiler
Camaro SS dash plaque
GM SS badges
Cannot tell it's a Z28 unless you look at the RPO codes
Stock bottom end LT1 5.7ltr
Ported, Polished, and Milled stock casting heads by AES in Chicago
Comp Magnum 1.6RR's
Comp 918 springs
Trickflow chromoly hardened pushrods
LS7 lifters
Crane 234/242 .574/.595 112 lsa w/1.6 rocker
Cam installed spring 2011
Ported and Polished Intake manifold
Ported and Polished throttle body
Port work done by AES in Chicago
Kooks 1 ¾ Long Tube headers
Kooks catless Y pipe
Borla XR1 dumped before axle
MSD ign module
NGK plus
SLP Blackwing CAI
Tuned by Madtuner/madz28
LT4 knock module
HID low beams
Summit Racing Shift light, installed in the driver side vent.
Stock T-56
Competition Clutch stg 2 (installed summer 2011)
Resurfaced flywheel
new Pilot Bushing
Pro 5.0 power tower shifter
UMI Pistol Grip
Poly Motor Mounts
BMR boxed subframe connectors
UMI lower control arms
UMI strut brace
SLP Drive shaft loop
Stock 10 bolt rear
Richmond 4.10's
OEwheels ZR1 Deep Dish replicas 17x9.5, 17x11 (fall 2010)
Nitto 555's 275,315's (90% tread)
LS1 front brake swap
***driverside mat is wet from my shoes, not stained.****
Comment