Welcome to the Michigan FBody Association website.
The Michigan FBody Association is a centralized website for FBody enthusiasts to discuss what's going on in the Michigan area. MiFbody.com was created to allow for an easy one-stop place to find out what's going on in Michigan as far as FBody events, to find out what clubs are available in your immediate area, and for an easy place to post classifieds for items you want to sell! Our goal was to create a more close-knit community of FBody enthusiasts in the state of Michigan, and to bring Camaro and Firebird enthusiasts alike together for some amazing FBody events!
The most important thing to know about the Michigan FBody Association is that we are NOT a club! The Michigan FBody Association is open to everyone, and is a community. Thus, we will have get togethers, casual cruises, events, and such like that, but this is not an exclusive club and it's 100% free to join this site! So what are you waiting for? Register now!
If you have any problems with the registration process or your account login, please contact us!
if u got a pair of eibach sportlines liek i think u said they will be a just like what mine are which wwere a 1.7 and 2 inch
That will even be fine. I just took those #'s off there web site. I'll have to get the part # off the box.
Oops I just it goes the other way **Note: Avg Low 1.6"F 1.3"R** I just looked at the web site again.
Another question, where a good place to buy some good sub-frame connectors? I'm thinking the bolt in ones. Just incase I want to take them off to do something.
That will even be fine. I just took those #'s off there web site. I'll have to get the part # off the box.
Oops I just it goes the other way **Note: Avg Low 1.6"F 1.3"R** I just looked at the web site again.
Another question, where a good place to buy some good sub-frame connectors? I'm thinking the bolt in ones. Just incase I want to take them off to do something.
Don't waste your time with bolt in connectors. Just get the weld in ones...you will never have to take them off....there would never be any reason to. Bolt in ones are fine for a short while but as soon as the bolts streach and the holes elongate, they are useless.
what if you blot them in......and then weld them? I have never seen a set on a car before. And I have never installed them before.
I'm looking for a good set that will tuck up nice, sense ill be lowering the car.
Did you have to do a front end alignment when you swapped your springs?
You should be able too rent a spring compressor too get your fronts done. We have a few rental places around here that rent them out, so you should have some out that direction also. Sweet drops by the way, and I am sure yours will look just as good once you drop it...
Tweet
Comment