Tweet
Well everyone might know or not but I swapped my "wonderwhich" rear end and put in a LSD rear end in. My speedometer is off and therefore I dont know how fast im going before it starts wobbling/vibrating. Im guessing around 60-65 mph it starts. When it does though its a pretty bad one too. In the rear view mirror I can see my whole window shaking and it goes all the way into your seat. I cant stand it. Anyone have any ideas of what it could be? Im thinking either the driveshaft is bent,loose, or off balance. What do you guys think??
-
1989 Camaro RS - SOLD
1991 Camaro Z28 - SOLD
1987 Camaro IROC-Z - current
When the rear end's loose, the car's fast. Loose is fast, and on the edge you're out of control. -
drive shaft not centered in the cups.bent axle shaft -
Have you had the alignment checked? The whole car not just the front end. Something else to check for ya.Comment
-
I dont think it should really need an alignment. It didnt do it until after i put in the rear end.
1989 Camaro RS - SOLD
1991 Camaro Z28 - SOLD
1987 Camaro IROC-Z - current
When the rear end's loose, the car's fast. Loose is fast, and on the edge you're out of control.Comment
-
the rear end needs to be aligned too. just as important at the front. i had bent axleshafts on one of my 94's. i didnt have any vibrations untill about 125. took them out and they were slightly tweaked98 z28, m6, monster clutch, eibach pro kit, custom twin turbo setup, 317 heads, z06 valve springs, arp rod bolts, 512rwhp at 10lbs. cobra eaterComment
-
alright looks like im going to get an appointment for an allignment.
1989 Camaro RS - SOLD
1991 Camaro Z28 - SOLD
1987 Camaro IROC-Z - current
When the rear end's loose, the car's fast. Loose is fast, and on the edge you're out of control.Comment
Comment