Tweet
so I had a friend come over because my oil pan on my new engine was leaking real bad I had to go out of town for work I come back today and he had droped the rear seal of the oil pan the ruber piece in the pan any ideas on how to get it out or what to do with out lifting the engine out I was hopeing to go for a ride I still havent even drivin it since the new engine I had to redo that gasket finish my exhaust now the exhaust is back off I am kinda pissed off now I shold have just waited and did it my self any ideas thanks
-
sigpic1999 Trans Am Bolt On Car plus Nitrous!
2009 Yamaha R6 -
I think you're gonna have to pull the pan...Gone but not forgotten: 1986 Chevrolet Camaro IROC-Z
"You shall ride eternal. Shiny and chrome." -
Have your FRIEND pull the pan!
Comment
-
ya your gonna have to pull the pan man...The Original
Originally posted by 81DaytonaPaceCarComment
-
no he will not be touching the car again he was just going to bolt it back up with it in there until my dad came by to see how he was doingOriginally posted by UjGearhead View PostHave your FRIEND pull the pan!sigpic1999 Trans Am Bolt On Car plus Nitrous!
2009 Yamaha R6Comment
-
Friend?sigpic
Why the Hell do I have to press 1 for english?!
Comment
-
umm, lube yer arm up nice n good and stick it down in there!
Comment
-
dont think it will fit lol but I did go get one of those grabber tools and I think I can get it with that I shook the pan a bit and now I can see it so I hope I can grab it and get this thing doneOriginally posted by MORNINGSTAR2101 View Postsigpic1999 Trans Am Bolt On Car plus Nitrous!
2009 Yamaha R6Comment
-
If you can see it, you can get it. Good luck!sigpic
Check out my 'bird: http://www.mifbody.com/vbulletin/sho...256#post325256Comment
-
yeah I was going to do the same when I swapped timing chain and gears for my car.
I was also going to change the oil pump.
Yeah you cant get that pan off without pulling the motor up.
we tried everything to get it out with the motor in the car.
no go.
I did manage to put the new oil pan gasket on.
YES, I did get it under the oil pump! LOL!
Talk about a tricky job!sigpicComment
-
I got the ruber out and new gasket on and the car is done now just need to have the ypipe welded to the exhaust and then I can take her for a spinsigpic1999 Trans Am Bolt On Car plus Nitrous!
2009 Yamaha R6Comment
-
Got lucky this time as for the friend...grab by throat and one way then the other with other hand should do the trick! LOL! JK!
burn rubber!Comment
-
nice work! sounds like you pulled off the impossible.2000 Trans Am l 1967 Firebird
sigpic
Comment
-
that boy for me
Man, you would have been screwed bad if your dad didn't come out.
Enjoy the ride
VicePresident of West Michigan Firebird Club
A.K.A The Maverick
http://www.cardomain.com/ride/660128/1
93 TA Currently Under Construction AGAIN
2007 2500 Chevy Silverado Crew Cab w/ 6.0L & 3.73'sComment
-
congrats man that would be a crappy friend if he wouldnt of told you.. glad it work out for you thoThe Original
Originally posted by 81DaytonaPaceCarComment
Comment