Ok so I bought a set of Fiero head light motors. (Thanks again Wade) I put the 1 on after having to mod part of it and now I can lower and raise my head light manually. So next I need to figure out where the relay is. I looked under the front end and traced the wire. From the motor it goes to a yellow box then a couple inches later goes to a black box. Is the yellow box a inline fuse? and the black box the relay?
Announcement
Collapse
No announcement yet.
Head light motor relay/fuse?
Collapse
X
-
\,,/>_<\,,/
- May 11th, 2006
- 10130
- Mark
- 2023 Malibu, 2022 Explorer
- Winston Salem, NC
- Manager of Telecom Engineering
- Send PM
Tags: None
-
\,,/>_<\,,/
- May 11th, 2006
- 10130
- Mark
- 2023 Malibu, 2022 Explorer
- Winston Salem, NC
- Manager of Telecom Engineering
- Send PM
The part that attaches to the little bar that moves the head light up and down was different. So just had to remove the nut, swap them then retighten the bolt. The old motor came off easy, then 1 I got from you I had to use a little persuasion to get it off.
Comment

Comment