2.5 questions

[badinfluence]

cant seem to find much about the 2.5 in fbodys

what parts are interchangeable from other engines? (V8 parts? newer 4 cyl parts?)

what bellhousing pattern does the engine have?

the car needs a exhaust manifold so i was thinking about buying a header (i dont think there are any made for it specifically) but i know you can get chevy sbc block huggers for under $100

[ITSSLOW]

Adam I have no damn clue but bumpin' it up to the top in hopes you get some answers!

[badinfluence]

thanks! lol

well wikipedia said its a 60 degree V6 bolt pattern but ya never know w/ that site

basically im wondering if one of these would fit on this beast:
http://store.summitracing.com/partde...5&autoview=sku

[MP81]

Did you check TGO?

...I just searched regarding the bellhousing - not a whole lot of info.

[badinfluence]

anyone know if this looks like a pontiac V8 header patten?

http://store.summitracing.com/partde...5&autoview=sku

i posted up on TGO too

[TSTONE]

didnt they use that motor to some degree for circle track racing - might check those suppliers?

[Orange Terror]

didnt they use that motor to some degree for circle track racing - might check those suppliers?

Like Slow track racing?

[81DaytonaPaceCar]

Try some Fiero performance sites...here's one:

http://ironduke7.tripod.com/builtduke.htm

[badinfluence]

i know a junk yard that has some fieros maybe ill go look there and see if the manifolds are any different

i also read for $7,000 you can make an iron duke out run a '96 corvette

[GETGONE]

LOTS of 80's cars came with the Iron Duke, Fieros, Grand Ams, Sunbirds, Olds Fierenza, Cutlass, Calais, Buick Century, Chevy S10/GMC S15's, Chevettes, Citations, Cavaliers. I think that's most of them but I'm sure I missed a few. Parts for the S10/S15's will be most interchangeable since they're the same front engine rear drive layout and are probably most common.