Fuel Line Conversion

[Fox Slaughter]

Does anyone know the fittings I would need to replace the fuel lines from the rail to the tank?

I want to reroute my fuel lines from the top of the gas tank to the rails to the outside of the frame rail for more space.
I have not dropped or seen the top of the assembly (can't think of the name for it right now), so does anyone know what I would need?

EDIT:

I found the items needed to connect to the fuel rail, now just where the lines come out of the fuel pump assembly.

http://www.jegs.com/i/JEGS-Performan...03100/10002/-1 Rail Return

http://www.jegs.com/i/JEGS-Performan...03101/10002/-1 Rail Feed

[Phantom409]

You going braided line or just rerouting the factory ones?

[Phantom409]

I'll have to get you pics of what I did.
Didn't have enough room to run the AN fittings the way I wanted so I cut the steel lines to the pump and did a AM crimp fitting then ran a 45 off that to my braided line.
Ran it right down next to the frame rail and attached it with padded rubber clamps and a rivet gun.

[Fox Slaughter]

You couldn't fit AN fittings on top of the fuel pump assembly? Are there more quick disconnects on top of the fuel pump assembly?

[Fox Slaughter]

Does anyone know the sizes of the lines coming out of the fuel pump assembly? Cause you can get Hardline to AN fittings.

[Phantom409]

They are 5/16 & 3/8

[Phantom409]

Here is the the fittings on the pump assembly.
I had to cut the steel lines to get this:
100_5095.JPG

I did the trap door on my car.
To get at AN fittings in the factory location is imposable and is why I cut the lines back

100_5096.JPG

[Fox Slaughter]

Hm now I could only find online hard line fittings for 3/8 and bigger no 5/16 where did you find one for the 5/16?

I will probably be having my axle out this winter so I will just drop the gas tank even though my car already has the trap door in it.

So you cut the lines back and flared the ends correct?

[Phantom409]

Nope, those are AN compression fittings.They have a brass compression flair inside that crushes when you tighten them.Got them at my local speed shop.I might be able to find the part #, I'll have to look.

[Fox Slaughter]

Hmmm. Cause I tried looking online for compression fittings AN. I didn't find much, I'll have to look into it more.

[Phantom409]

Here ya go:
http://www.jegs.com/p/Earls/Earls-Ha...49418/10002/-1

[Fox Slaughter]

Sweet! Thank you.

[Phantom409]

Areoquip stuff, the whole site is cool:
http://aeroquip.cc/aeroquipversil-fl...dferrules.aspx

[Fox Slaughter]

Anyone know a good -6AN both side inline filter?

[Phantom409]

You still running a LT 1 filter setup?