New toys in the mail

[Kwazrollinz28]

well got some stuff while i was up north, I got my cam and 30# injectors
And my High flow Oil pump.

Now all i need is an oil pan, A-arm bushings, wheel hubs, Intake block off plates, and Port the intake. and order some POR for my new rear end.

there's a few other things But I'll wait to say.
Gonna be sad seeing my car in a million pieces again

[Phantom409]

I could have saved you money on that 306 cam.

Nice stuff

[Kwazrollinz28]

i payed 250 with shipping wasn't to bad.
i can finally say bye bye to this dammed 502 cam.

[meissen]

Congats Steve!

[Boost Addict]

What ratio rockers is that advertised with?

[Kwazrollinz28]

Not sure but i'll be using my 1.6 stainless steel roller rockers. with the compcam Push rods.

[MP81]

Congrats man, hope everything goes smooth!

[Kwazrollinz28]

im so excited

http://www.youtube.com/watch?v=mqE3IscTbP8

http://www.youtube.com/watch?v=oZhim...e=channel_page

http://www.youtube.com/watch?v=odgwh...e=channel_page

http://www.youtube.com/watch?v=PGiLm...e=channel_page

[MP81]

That's got a nice chop to it!

[Kwazrollinz28]

yeah it does I'm putting the 502 cam in the 95 White Z28 since it'll be just a cruiser and Need gas mileage along with Not being to much power.

I'm still gonna DD my 94Z as much as possible if at all possible with how much down time im looking at.

[LSxDreamer]

Congrats man! That's the cam I would have if I owned an LT1. I love the choppy idle.

[BP_Z28]

woot ! Nice. Install party?lol

[Kwazrollinz28]

hmmmm yeah i never thought of an install party, But i have to take the front of the car off, The Subframe needs to be dropped and the top of the engine needs to be removed, along with hanging the motor and trans with the car while i do all this work.

It's really not a lot to be needed for an install/start up party but everyones welcome to come. pizza and pop as always lol

[phoenix_rising]

Hell yeah! Thats a nice cam bro.

[OIF1VET]

New stuff is always nice!!!